F5F Stay Refreshed Power Users Networks Upload rate is significantly reduced compared to download speed on Windows 10.

Upload rate is significantly reduced compared to download speed on Windows 10.

Upload rate is significantly reduced compared to download speed on Windows 10.

Pages (3): Previous 1 2 3 Next
C
CRAZYMAN4590
Member
164
08-05-2016, 06:05 PM
#11
I still find it surprising it took about 20 minutes to complete this task. It seemed straightforward. Your guidance was really helpful. I ran a similar speed test using the same browser on Linux Mint booted from USB, and the results were acceptable—roughly 470 Mbps down and 540 Mbps up. This suggests my hardware (MoBo/WiFi module and antenna) is functioning properly, while the issue likely lies in software. That’s good news. Now what should I do? I’ve heard about potential conflicts between TCP/IPv4 and v6 protocols. I’ve tried disabling the box for IPv6 in network settings, but the outcome remained unchanged. If I turn off the IPv4 connection, it stops working entirely.
C
CRAZYMAN4590
08-05-2016, 06:05 PM #11

I still find it surprising it took about 20 minutes to complete this task. It seemed straightforward. Your guidance was really helpful. I ran a similar speed test using the same browser on Linux Mint booted from USB, and the results were acceptable—roughly 470 Mbps down and 540 Mbps up. This suggests my hardware (MoBo/WiFi module and antenna) is functioning properly, while the issue likely lies in software. That’s good news. Now what should I do? I’ve heard about potential conflicts between TCP/IPv4 and v6 protocols. I’ve tried disabling the box for IPv6 in network settings, but the outcome remained unchanged. If I turn off the IPv4 connection, it stops working entirely.

T
turnen02
Junior Member
17
08-07-2016, 01:46 AM
#12
Most home users use IP4, not IP6, so you can safely disable IP6. Regarding Windows, it presents a challenge. First, confirm your Wi-Fi hardware is operating at maximum capacity continuously. Windows often powers down Wi-Fi devices unexpectedly, especially on desktops. Check the Device Manager and the Wi-Fi settings to verify power status. The relevant section should clearly show how to maintain full power for your Wi-Fi card.
T
turnen02
08-07-2016, 01:46 AM #12

Most home users use IP4, not IP6, so you can safely disable IP6. Regarding Windows, it presents a challenge. First, confirm your Wi-Fi hardware is operating at maximum capacity continuously. Windows often powers down Wi-Fi devices unexpectedly, especially on desktops. Check the Device Manager and the Wi-Fi settings to verify power status. The relevant section should clearly show how to maintain full power for your Wi-Fi card.

T
themojigamer
Junior Member
4
08-08-2016, 11:20 AM
#13
Journey continues... Thank you for sticking with me. I appreciate your patience. Initially, I turned off TCP/IPv6 and the tests yielded consistent outcomes. Following your advice, I checked the Power Management settings on my WiFi module and disabled the power-saving option. No changes detected. Interestingly, after disabling that setting, my PC crashed with a blue screen immediately, though it restarted afterward and appears stable now. I've experimented with several fixes: switched to a 2 GHz WiFi signal instead of 5 GHz (my router supports dual networks), performed speed tests showing downloads around 100 Mbps and uploads under 15-20 Mbps, reinstalled the module after uninstalling it, and even tweaked network adapter properties. Still no success. I'm feeling a bit exhausted from all this troubleshooting. I plan to keep working on it tomorrow after work. Stay safe!
T
themojigamer
08-08-2016, 11:20 AM #13

Journey continues... Thank you for sticking with me. I appreciate your patience. Initially, I turned off TCP/IPv6 and the tests yielded consistent outcomes. Following your advice, I checked the Power Management settings on my WiFi module and disabled the power-saving option. No changes detected. Interestingly, after disabling that setting, my PC crashed with a blue screen immediately, though it restarted afterward and appears stable now. I've experimented with several fixes: switched to a 2 GHz WiFi signal instead of 5 GHz (my router supports dual networks), performed speed tests showing downloads around 100 Mbps and uploads under 15-20 Mbps, reinstalled the module after uninstalling it, and even tweaked network adapter properties. Still no success. I'm feeling a bit exhausted from all this troubleshooting. I plan to keep working on it tomorrow after work. Stay safe!

V
Viizion_PvPz
Senior Member
670
08-09-2016, 12:31 AM
#14
This matters, likely a crash dump exists in C:\windows (perhaps under a subfolder named "minidumps"). Upload it so I can analyze and identify the cause. This is expected. The recommended values are 2.4 for the traditional setting and 5 for the newer, faster option. Let's proceed.
V
Viizion_PvPz
08-09-2016, 12:31 AM #14

This matters, likely a crash dump exists in C:\windows (perhaps under a subfolder named "minidumps"). Upload it so I can analyze and identify the cause. This is expected. The recommended values are 2.4 for the traditional setting and 5 for the newer, faster option. Let's proceed.

W
Wrecktangl3
Junior Member
10
08-10-2016, 08:50 PM
#15
Here is the attached ".dmp" file for the specific incident. File name: 011221-4750-01.dmp
W
Wrecktangl3
08-10-2016, 08:50 PM #15

Here is the attached ".dmp" file for the specific incident. File name: 011221-4750-01.dmp

C
CrazyWolfZ_
Junior Member
22
08-11-2016, 09:49 PM
#16
Argument 1: ffffffffc0000005 Exception code not resolved Argument 2: fffff800397fd6b7 Address where it happened Argument 3: fffffe823b77cd98 Exception parameter 0 Argument 4: ffffe6812d748920 Parameter 1 of the exception Symbol name: Ndu!NduInboundMacClassify MODULE_NAME: Ndu IMAGE_NAME: Ndu.sys Image version 10.0.19041.1030 Stack command: .thread ; .cxr ; kb Bucket ID FUNC_OFFSET: 1ff Failure bucket ID: 0x1E_c0000005_STACKPTR_ERROR_Ndu!NduInboundMacClassify OS version 10.0.19041.1 BUILDLAB_STR: vb_release OSPLATFORM_TYPE: x64 OS NAME: Windows 10 Follow-up: Check the ndu.sys file, probably a Wi-Fi module driver is outdated.
C
CrazyWolfZ_
08-11-2016, 09:49 PM #16

Argument 1: ffffffffc0000005 Exception code not resolved Argument 2: fffff800397fd6b7 Address where it happened Argument 3: fffffe823b77cd98 Exception parameter 0 Argument 4: ffffe6812d748920 Parameter 1 of the exception Symbol name: Ndu!NduInboundMacClassify MODULE_NAME: Ndu IMAGE_NAME: Ndu.sys Image version 10.0.19041.1030 Stack command: .thread ; .cxr ; kb Bucket ID FUNC_OFFSET: 1ff Failure bucket ID: 0x1E_c0000005_STACKPTR_ERROR_Ndu!NduInboundMacClassify OS version 10.0.19041.1 BUILDLAB_STR: vb_release OSPLATFORM_TYPE: x64 OS NAME: Windows 10 Follow-up: Check the ndu.sys file, probably a Wi-Fi module driver is outdated.

E
Ender_Craft47
Posting Freak
866
08-12-2016, 10:26 PM
#17
Hey, me again. I have already installed latest WiFi module drivers from official Intel site few days ago. Double checked adapter model and all. I have latest drivers from 2020 November. Unless there is other "NIC drivers" that I am not aware of. I will keep dinging and let you know if find something interesting. Stay safe!
E
Ender_Craft47
08-12-2016, 10:26 PM #17

Hey, me again. I have already installed latest WiFi module drivers from official Intel site few days ago. Double checked adapter model and all. I have latest drivers from 2020 November. Unless there is other "NIC drivers" that I am not aware of. I will keep dinging and let you know if find something interesting. Stay safe!

R
RedFoxxGaming
Member
178
08-14-2016, 12:40 AM
#18
R
RedFoxxGaming
08-14-2016, 12:40 AM #18

A
Asianbv
Member
61
08-14-2016, 02:04 AM
#19
Yes, it is a European internet service provider.
A
Asianbv
08-14-2016, 02:04 AM #19

Yes, it is a European internet service provider.

K
Kangmiester18
Member
115
08-14-2016, 07:07 AM
#20
Hello! I see you're located in Latvia.
K
Kangmiester18
08-14-2016, 07:07 AM #20

Hello! I see you're located in Latvia.

Pages (3): Previous 1 2 3 Next