Two of four RAM modules remain stuck at 2133 MHz rather than the correct 2666 MHz, even though DOCP is activated.
Two of four RAM modules remain stuck at 2133 MHz rather than the correct 2666 MHz, even though DOCP is activated.
Bonjour ! Je suis nouveau ici et je comprends que mes erreurs grammaticales peuvent être un peu grossières. (Je n'ai pas trouvé de réponse sur le forum français.) Aujourd'hui, j'ai mis à niveau mon RAM de 2*4Gb 2666Mhz à 4*4Gb 2666Mhz. Mais quand je démarre mon PC et que je vais dans le BIOS, deux de mes modules ne sont pas à 2666Mhz, ils affichent 2133Mhz même avec le D.O.C.P. actif. Je me demande si c'est normal ou pas ? Si ce n'est pas le cas, comment puis-je les ramener à 2666Mhz ? Mon CPU est un Ryzen 5 2600G, la carte graphique Gtx 1660, le boîtier Asus Tuf B450-PLUS, et j'ai installé des modules de mémoire de 2*4Gb 2666Mhz et 2*4 Corsair Vengeance LPX. Le BIOS était à jour récemment (version 2409). Si quelqu'un peut m'aider, je serais très reconnaissant ! (Je suis aussi un peu mal à l'aise avec les instructions techniques, donc je pourrais poser beaucoup de questions plus tard.) Merci !
Enter values directly by hand because results vary with motherboard and RAM.
Hello, you have control over the speed setting. For timing, use the appropriate value based on your needs—check the recommended range or test different numbers to find what works best.
Focus on the CAS latency first; the rest matter less. If you're unsure, go with auto—it's usually the best choice. The difference is usually just 1-2%, and often not noticeable.
It seems you're asking if it's feasible to operate the device at 2666 without adjusting the timing, given that you purchased it at its full price.
The issue is that both Corsair cards are stuck at 2133 MHz. They won’t accept the change to 2666Mhz right now.