The new PC build fails to install any operating system.
The new PC build fails to install any operating system.
Never starts up from the BIOS. It connects to the BIOS instead. And it does so consistently each time it attempts to load an operating system. The ideal process is for the machine to examine the boot sequence and search for relevant information on every type of device. If your setup includes a new computer, there will be no bootable OS on the SSD, prompting it to verify and continue searching. Devices not listed in the boot order cannot be accessed. Once something is found, the system can launch from it, though this may take a while—especially with CD drives. Eventually, after installing an OS, you should reach a basic screen that doesn’t resemble a traditional desktop environment on Windows. With a Linux live CD, a prompt like “Would you like to install Linux?” appears. Under Windows, the display tends to be mostly blue and prompts for keyboard preferences.
Seen no NVMe drive with a grey end before. Could be padding or wear? Possibly just a reflection. Edited December 11, 2022 by Bombastinator
The protective paste was included with the SSD case. Every slot displays it. Unless I had to take it off too!
It seems like the sticker got damaged, which isn’t a big deal right now. Usually, aligning the standoff correctly helps fix things. For a fast temporary fix during testing, simply place tape over it—just remember this isn’t a long-term fix.
I observed those two interfaces on both Windows and Linux systems. On the BIOS, I chose the drives available—USB and ISO—and set the boot sequence accordingly. For Linux, there’s an option to launch the OS; however, on Windows it displays a mostly blue screen with "install now," which then crashes after pressing install.
You're observing a heat sink for an M.2 drive, possibly from an MSI mortar or tomahawk motherboard, with the protective outer shield still attached. There seems to be another piece of foam tape nearby, which might just be leftover 3M foam tape. The heat sink itself isn't crucial, but keeping the tape on doesn't harm it much—though it does affect its performance. It’s not essential, but it won’t cause major issues.
Observed those screens before on other machines to clarify what I mean? Or when attempting to load the operating system on this one? Then the process starts on the drive and immediately stops when it tries to install. It might be the drive is faulty, the connection is damaged, or the motherboard has issues. On MSI boards (possibly different on your ASUS) you usually secure the drive with a screw in the heat sink or use a plastic clip with a threaded top for the heat sink to fit. It’s possible the stick doesn’t fully insert into its connector on the board, yet the screw still goes in tightly. You could try unscrewing and reinserting the M.2, making sure it’s pushed in completely the second time. This shouldn’t be a problem since the drive is recognized by the OS, but the connection might be incomplete. Edited December 11, 2022 by Bombastinator
I observed both during the OS installation process on this PC. For Windows and Linux, I managed to proceed through the initial stages, but beyond a few steps I encountered difficulties. The same applies to Arch Linux, where I could simply access the main menu. Once I pressed "Install now," the system became unresponsive.