F5F Stay Refreshed Hardware Desktop System starts in 3 seconds and stops immediately afterward

System starts in 3 seconds and stops immediately afterward

System starts in 3 seconds and stops immediately afterward

Pages (2): 1 2 Next
R
RLMAO
Junior Member
7
01-11-2017, 09:30 PM
#1
Hi everyone, I've been using my system for four years and everything was fine until yesterday. After a two-day trip, I came back home but it wouldn't boot at all—nothing happened when trying to power it on. When I unplugged and plugged the power cable back in, the fans (including the CPU) spun up for three seconds before shutting down again. I tried booting it again later, and it worked for about an hour before shutting itself off. Leaving it plugged in, it attempted to restart after a few minutes and then shut down after three seconds. I suspect the power unit (PU) might be the issue, similar to what happened with my old machine, but it managed to run for an hour now.

My current specs are: MSI B350M PRO-VDH, AMD Ryzen 5 1600, 4GB RAM, MSI GeForce GTX 1050 Ti. It's running at around 10,400 watts with G-Skill Aegis DDR4-3000.

What I've done: performed a CMOS reset and used different outlets. Any advice would be appreciated! Thanks in advance!
R
RLMAO
01-11-2017, 09:30 PM #1

Hi everyone, I've been using my system for four years and everything was fine until yesterday. After a two-day trip, I came back home but it wouldn't boot at all—nothing happened when trying to power it on. When I unplugged and plugged the power cable back in, the fans (including the CPU) spun up for three seconds before shutting down again. I tried booting it again later, and it worked for about an hour before shutting itself off. Leaving it plugged in, it attempted to restart after a few minutes and then shut down after three seconds. I suspect the power unit (PU) might be the issue, similar to what happened with my old machine, but it managed to run for an hour now.

My current specs are: MSI B350M PRO-VDH, AMD Ryzen 5 1600, 4GB RAM, MSI GeForce GTX 1050 Ti. It's running at around 10,400 watts with G-Skill Aegis DDR4-3000.

What I've done: performed a CMOS reset and used different outlets. Any advice would be appreciated! Thanks in advance!

C
Candyx
Member
55
01-11-2017, 11:17 PM
#2
Refresh the memory module
Replace the existing RAM with a new one
Upgrade your system performance
C
Candyx
01-11-2017, 11:17 PM #2

Refresh the memory module
Replace the existing RAM with a new one
Upgrade your system performance

J
jack1821
Member
64
01-12-2017, 01:03 AM
#3
It seems like PSU is the plan. Also, make sure to look inside for any intruder, as you didn't monitor it for two days.
J
jack1821
01-12-2017, 01:03 AM #3

It seems like PSU is the plan. Also, make sure to look inside for any intruder, as you didn't monitor it for two days.

I
ItzCh3nTi_YT
Member
96
01-12-2017, 02:45 AM
#4
Revisiting food. The creator isn't growing plants.
I
ItzCh3nTi_YT
01-12-2017, 02:45 AM #4

Revisiting food. The creator isn't growing plants.

M
MrManoLP_
Junior Member
35
01-15-2017, 07:52 PM
#5
It seems you might need to purchase new seeds to replenish your rams.
M
MrManoLP_
01-15-2017, 07:52 PM #5

It seems you might need to purchase new seeds to replenish your rams.

M
MikHaven
Member
54
01-15-2017, 08:29 PM
#6
I experienced an older setup where the PSU fan stopped functioning, showing a comparable pattern. It operated briefly before stopping, then would restart and immediately shut down again unless left on for some time. This issue seemed linked to the PSU's overtemperature protection. Would you have another PSU to test? Or another system that could accommodate it?
M
MikHaven
01-15-2017, 08:29 PM #6

I experienced an older setup where the PSU fan stopped functioning, showing a comparable pattern. It operated briefly before stopping, then would restart and immediately shut down again unless left on for some time. This issue seemed linked to the PSU's overtemperature protection. Would you have another PSU to test? Or another system that could accommodate it?

T
TheMrJokerJ
Member
118
01-16-2017, 01:34 AM
#7
It seems like a fragile 5v stand-by setup... This type of stand-by power feeds the chipset that manages the boot sequence. If the capacitors in your power supply degrade, the 5v output might fluctuate when the chipset begins using power during startup and initialization phases. When instability occurs, the chipset can trigger a reset or shutdown. You often notice the capacitors failing by swelling or leaking fluid on the power supply; opening it up and checking visually could help determine if this is the issue.
T
TheMrJokerJ
01-16-2017, 01:34 AM #7

It seems like a fragile 5v stand-by setup... This type of stand-by power feeds the chipset that manages the boot sequence. If the capacitors in your power supply degrade, the 5v output might fluctuate when the chipset begins using power during startup and initialization phases. When instability occurs, the chipset can trigger a reset or shutdown. You often notice the capacitors failing by swelling or leaking fluid on the power supply; opening it up and checking visually could help determine if this is the issue.

T
228
01-26-2017, 03:55 AM
#8
I’ve started it up now and it looks quite typical to someone without experience. I attempted to reinsert my RAM, but that didn’t help.
T
Thegamingnerds
01-26-2017, 03:55 AM #8

I’ve started it up now and it looks quite typical to someone without experience. I attempted to reinsert my RAM, but that didn’t help.

R
Reltzy
Member
111
01-26-2017, 05:40 AM
#9
No sadly not. I would need to buy one to test if that’s the problem
R
Reltzy
01-26-2017, 05:40 AM #9

No sadly not. I would need to buy one to test if that’s the problem

X
xAdriLCT
Senior Member
702
01-26-2017, 12:22 PM
#10
It seems like you're facing an unusual situation. Other than checking voltages with a multimeter while the computer fails to start, there aren't many obvious solutions right now.
X
xAdriLCT
01-26-2017, 12:22 PM #10

It seems like you're facing an unusual situation. Other than checking voltages with a multimeter while the computer fails to start, there aren't many obvious solutions right now.

Pages (2): 1 2 Next