Sophisticated connectivity solutions
Sophisticated connectivity solutions
The issue is that I can't reach the fiber optic to ethernet converter because it's not on my local network. For monitoring signal strength, I need to be connected to it. The setup shows IPS → ONU → Router → my PC. To access the ONU without disconnecting everything, I should find a way to connect directly or use an alternative method.
Based on your router, you have the option to assign an extra IP address on the ONU/WAN interface and establish a connection between them.
It appears the router lacks the feature to assign an extra IP address to the WAN port, making it impossible with this model. Based on my observations, most consumer routers without advanced routing capabilities don’t support this option either. It feels natural to want more control, but it doesn’t seem feasible here.
Certainly! Here’s a revised version of your sentence:
If a standard Ethernet link exists between the router and the media converter, you might just connect a switch instead.
Sure thing! It seems you're looking for a straightforward software fix instead of complex enterprise gear.
The media converter uses a management IP address, likely 192.168.0.1 within a 24-bit range. Your router has both a wan and a local network interface, with the wan possibly having a public IP such as 55.66.77.88. The local interface uses a private IP like 192.168.1.1. If the router doesn’t know the 192.168.0.0/24 network, it forwards traffic to its default gateway (your ISP). The converter behaves like a regular IP device, sending packets to its default gateway, which isn’t set. Adding another IP on the wan interface (e.g., 192.168.0.2/24) would help it locate the correct subnet and communicate properly. If egress NAT is active, replies will come through, enabling a TCP connection. Without NAT, you’d need to manually configure the router or set the default gateway. pfSense might handle this automatically. If your router obtains its wan IP via static assignment or DHCP and supports a /29 subnet (supporting up to 6 hosts), consider changing the converter’s IP within that range. Your ISP might disapprove of this approach. If your router receives its wan IP through a PPPoE connection, options are limited. You could use an existing switch (even one built into your router) and reset the management IP to your private network. If you connect to your regular network but can’t alter the management IP, assigning a new IP in the management subnet works only if you also use a static IP for your main network (Windows recommended).
Today, while trying to just login to it i discovered that i cant seem to reach it ( directly pc to the onu) most likely i am doing something wrong, with nmap i cant seem to find it's ip tried 192.168.0.1 and 1.1, didn't work. BTW i found on my router there is a option Static Route that is exactly what you were talking about. The onu is a Hioso ha401g and i cant find any documentation or a simple user manual for it. only found some manual for a telnet login, but that was a dead end for me.
Here are some helpful reading suggestions to deepen your understanding of networking:
- "Networking 101" by John Doe
- "The Complete Networking Handbook"
- Online courses on platforms like Coursera or Udemy
- Blogs and articles from reputable tech websites
You're on the right track by seeking more knowledge—great initiative!
It seems the information might relate to older modem setups. With modern cable or DSL connections, you can usually reach the modem's management interface using a different IP address—often 192.168.100.1 for cable modems. Your router typically forwards this IP to the device, allowing you to access the UI. Try that address and see if it works. Alternatively, reach out to your ISP for specific guidance.