SFF build created for a friend. No display on any GPU. Windows 10 installation failed due to outdated GPU.
SFF build created for a friend. No display on any GPU. Windows 10 installation failed due to outdated GPU.
Once CMOS was reset, the GPU began to show, indicating the problem seems resolved. However, Windows 11 still doesn’t recognize the drive, even though installation appears possible. It’s possible the motherboard automatically set it up in RAID. You might want to attempt a BIOS flash to check if that fixes the display issue. Since you’re booting into UEFI now, the cause could be related to that setup.
Ensure the M.2 drive fits correctly in its designated slot, as configurations vary by manufacturer. Verify the slot is active in the BIOS settings and refer to your user manual for precise placement. If the system fails to recognize the drive at all, it may be improperly installed or defective. It’s unlikely a BIOS issue is the cause, since the default behavior restores CMOS and prepares the drive for use.
Begin by updating the BIOS, then attempt to install Windows 10. Once that's done, we'll investigate why version 11 isn't functioning properly.
Bios is acknowledged, it appears, and it seems to be the primary M.2 port as it was the first mentioned in the guide. I confirmed I’ll install the Bios update, check if Windows 10 and 11 function properly, and report back on the outcome.
Yes, the M.2 drive appears in the BIOS under your installed storage options. It may not be visible in the Windows installer. Check the BIOS settings for your storage drives to confirm its presence. If you share a photo of the BIOS display, I can help interpret it.
Refer to the details below—I also encountered an extremely intriguing error message related to the GPU. The attached file clarifies why CSM was activated.