Performance drops significantly when using XMP settings on this model.

F5F Stay Refreshed Hardware Desktop Performance drops significantly when using XMP settings on this model.

Pages (2): Previous 1 2

niuhayan
Member

165

10-20-2019, 11:34 PM

#11

I’ll run additional tests after work. I think the score will fall more at 3200 because the fclock will sync down. Just a guess.

niuhayan

10-20-2019, 11:34 PM #11

I’ll run additional tests after work. I think the score will fall more at 3200 because the fclock will sync down. Just a guess.

Aushellos
Junior Member

10-21-2019, 03:28 AM

#12

Just to clarify, try setting the clock speed above 266MHz if possible while maintaining stability. Increase the frequency further and allow it to lose synchronization. That should work.

Aushellos

10-21-2019, 03:28 AM #12

Just to clarify, try setting the clock speed above 266MHz if possible while maintaining stability. Increase the frequency further and allow it to lose synchronization. That should work.

xSneik
Member

178

10-21-2019, 04:52 AM

#13

Auto memory timings produce unusual performance, adjust them via Typhoon Burner and DRAM Calculator.

xSneik

10-21-2019, 04:52 AM #13

Auto memory timings produce unusual performance, adjust them via Typhoon Burner and DRAM Calculator.

i3z___
Senior Member

559

10-21-2019, 06:58 AM

#14

I thought the poster was right. I just changed the values manually instead of using XMP, and my results went back to normal. It's strange I didn't see any improvement. Latency dropped a few points, which is okay for now. I'll do more tuning later. Right now I'm not reaching 4.5ghz as often as I want. Solidworks is mostly single-threaded, so I'd like to boost that performance.

i3z___

10-21-2019, 06:58 AM #14

phoebegracemk
Member

125

10-22-2019, 10:52 AM

#15

The settings are quite flexible at that frequency.

phoebegracemk

10-22-2019, 10:52 AM #15

The settings are quite flexible at that frequency.

Jerrex
Member

175

10-22-2019, 12:41 PM

#16

3600

Jerrex

10-22-2019, 12:41 PM #16

3600

benice45
Member

230

11-13-2019, 06:54 AM

#17

I removed the XMP file and adjusted the timing manually, and it functioned properly. The XMP adjustments might have been altered elsewhere.

benice45

11-13-2019, 06:54 AM #17

I removed the XMP file and adjusted the timing manually, and it functioned properly. The XMP adjustments might have been altered elsewhere.

Pages (2): Previous 1 2