Observing the Aurora Borealis after startup
Observing the Aurora Borealis after startup
No, I want to clarify if you've made any changes.
What exactly are you referring to when you say "stuck"? Are they stuck in a particular position or section?
I'm assuming Display Port isn't compatible with daisy chaining, so do you have separate HDMI cables for each device?
I assumed the connection was correct. Actually, I used HDMI before switching to DP last year with a new card. Did everything work fine then?
They all work fine, actually. It seems the HDMI connection might have been faulty before switching to DP, and those DP cables could have been affected by bending. I’ll replace them later if possible. The problem appears only when the system starts up.
The monitor supports G-sync and free sync, and you can enable them in their OSD. There was an issue where the bottom 5% of the screen would display during long periods of inactivity, which resolved by disabling those features in the OSD. Alternatively, adjusting the refresh rate might have helped.
Yes, but differently. One monitor warms up slowly, another does it in a minute, and the third gets ready quickly. I think changing the cables between them could help, so I’ll try that next time I need to shut it down for a while. Should be tomorrow. 2 Only once. And I was hoping it would fix itself. 3First I had three identical BENQ monitors, but I lost the model now. Now I have the same AOC G1 series. The AOC monitors support Free Sync, but I’m using an NVifdia card. Do these features work? I’m not sure what OSD is either.