Issue with RAM, please clarify!

141

11-13-2020, 08:43 PM

Hi there, it seems your system displays a different speed than what you installed. This could happen if BIOS settings or RAM timings were changed after installation. Double-check the RAM type and ensure it matches the specifications. If the issue persists, revisit the BIOS configuration to confirm the correct values.

Rinusvandijk

11-13-2020, 08:43 PM #1

Cute_Ari
Member

11-14-2020, 02:38 AM

Ensure the switch labeled "XMP: Disabled" is chosen, then pick the corresponding XMP profile such as "3200 C16-18-18-36".

Cute_Ari

11-14-2020, 02:38 AM #2

Ensure the switch labeled "XMP: Disabled" is chosen, then pick the corresponding XMP profile such as "3200 C16-18-18-36".

ItzHayds_
Member

119

11-14-2020, 03:59 AM

Today felt a bit more puzzling? =) The FakeKGB mentioned setting X.M.P. to enabled on your screenshot.

ItzHayds_

11-14-2020, 03:59 AM #3

Today felt a bit more puzzling? =) The FakeKGB mentioned setting X.M.P. to enabled on your screenshot.

alerabbit
Posting Freak

840

11-20-2020, 06:06 AM

XMP serves as an overclocking setup, with 3200 being the maximum brightness level supported. This is the reason you must turn it on, since the device won’t automatically reach that speed when installed.

alerabbit

11-20-2020, 06:06 AM #4

GaymerTommy21
Member

152

11-20-2020, 01:55 PM

XMP is already active. It seems the picture existed prior to that. I found various different values scattered throughout. The DRAM status displayed 2133, while the "Memory:" section showed another number. I adjusted a few parameters to 3200 and then turned on XMP before saving. The image in my first post was likely before those tweaks. These pictures display the present configurations.

GaymerTommy21

11-20-2020, 01:55 PM #5

rafinha_moraes
Member

189

11-20-2020, 02:38 PM

It confirms the system is operating at 3200, everything appears fine. The 2133 value seems fixed in the code.

rafinha_moraes

11-20-2020, 02:38 PM #6

It confirms the system is operating at 3200, everything appears fine. The 2133 value seems fixed in the code.

sixpar
Member

137

11-20-2020, 05:37 PM

I believe the system is capped at 2133 only in BIOS settings. Try launching Windows and check the Performance tab under Memory for speeds around 3200MHz. Your current reading is 2667, likely due to B460 architecture but intended to highlight the correct range.

sixpar

11-20-2020, 05:37 PM #7

iiSweeTzz
Posting Freak

862

11-20-2020, 06:31 PM

It shows 3200, which suggests it's likely functioning, though the BIOS might be having trouble reading or showing it as Kilrah pointed out.

iiSweeTzz

11-20-2020, 06:31 PM #8

It shows 3200, which suggests it's likely functioning, though the BIOS might be having trouble reading or showing it as Kilrah pointed out.