Display loading interfaces on the M.2 drive
Display loading interfaces on the M.2 drive
You're experiencing a problem where only the second slot and chip show up in the BIOS, while your M.2 device isn't visible elsewhere. This issue persists across attempts, and you haven't changed any settings. Please let me know if you need further assistance.
Turn off the CSM module and connect just the M.2 drive, removing the other HDDs.
I don't notice much variation, regrettably. Probably because I made a mistake.
I never configured a raid setup, nor did I plan to. There aren't any active settings visible.
For Intel CPUs, you must transfer the Intel Rapid Storage drivers onto the USB bootable disk found at the provided link.
You enter the select drive window and must pick the load driver choice, then locate the drivers on the USB (don’t forget to unzip them)
I'm checking multiple drivers but the drive isn't visible, especially not in RAID.