Activation of xmp turns off the monitors.
Activation of xmp turns off the monitors.
Hello, I built my PC yesterday and checked the RAM speed. It was set to 2133MHz, but I have a 3200MHz RAM. I tried using XMP and switching the RAM to 3200MHz, but after applying those changes, the monitor shut down completely. My keyboard and mouse stopped working too, but the PC is still on. I’m not sure how to reset the settings now. Please help me.
I restored the CMOS and everything is functioning, but I'm unsure how to configure the 3200MHz clock. When I activate XMP profiles 1 or 2 at that speed, the display either appears or disappears abruptly.
The processor's memory controller is limited to 2933mhz. Begin the OC at 2667mhz and gradually raise the speed until it becomes unstable or fails. Once stable, return to a consistent frequency. A jump of about 500mhz from 2133mhz should help. Good luck!
I've tested both 2400 MHz and 2666 MHz, but it fails immediately—starts working but then shuts down after a few seconds. I'm unsure what's causing the issue.
The system seems to dislike the memory kit. Running iGpu in Async might be adding issues. Consider enabling XMP and manually adjusting the frequency to 2400—check if it works. Also, set the memory voltage to 1.35v. Experimenting could help reach around 2400mhz, though outcomes are uncertain.