4 RAM sticks offer more capacity compared to 2, providing greater overall performance and stability.
4 RAM sticks offer more capacity compared to 2, providing greater overall performance and stability.
I've observed content from makers such as Jayztwocents explaining why 2x RAM sticks (8GB each) outperform 1x (16GB single) but haven't tested 4x versus 2x. Whether you'll see better results with 4x 8GB sticks compared to your current 2x 16GB setup depends on the specific workload and system configuration.
Usually the ranking of RAM matters most. I found an article suggesting 4x4GB performs slightly better than 2x8GB; it’s hard to locate. The main impact seems to be on gaming frame rates. Also, with a motherboard that only has four slots, forcing all four to 16GB can limit upgrades. I’d suggest starting with half your RAM slots and reserving the other half for later additions.
I understand locking all four slots might seem excessive, but as a gamer I’d likely have more than enough for now. A 32GB system with 3200mhz RAM is plenty, and most people suggest 16GB. By the time I upgrade to DDR5, I probably won’t need much more memory. If I used smaller configurations like 4GB×4 or 8GB×2, leaving some slots open would make sense. By then, the standard might shift to DDR5, so 32GB could become outdated. Does this logic align with your thoughts?
Proceed, I'm utilizing 48GB of RAM. It includes two 8GB modules and two 16GB modules; the 16GB module was just installed recently.
You’re not following any of the YouTubers you see. I didn’t review each video on YouTube.
Based on what I've gathered, it seems the DIMM slot rank matters and the motherboard's layout plays a role. The OCN team mentioned that for their X299 boards, they use a T-topology to link the DIMMs with the CPU's memory controller, suggesting you should utilize all eight slots rather than just four. Despite changing from 16GB x 4 at 3200MHz CL14 to 8GB x 8 at 3600MHz CL16, I haven't observed any noticeable changes.
It likely depends on the specific use case and how much heat it generates. I’d suggest using a quad-channel configuration to fill every DIMM slot. For most gaming scenarios, even with more slots, the performance gain is minimal. Often, you have to balance speed against capacity, as trade-offs are common.