Your RAM isn't reaching 3200 MHz.

F5F Stay Refreshed Hardware Desktop Your RAM isn't reaching 3200 MHz.

Your RAM isn't reaching 3200 MHz.

Your RAM isn't reaching 3200 MHz.

T

Tchainiz
Junior Member

38

12-01-2016, 07:33 PM

#1

Ram model PVS416G320C6K from Hynix. Mobo H610M DDR4 REV 1.2 with BIOS v29. CPU I3 12100F. Issue is booting fails without XMP support, showing error warnings or needing CMOS reset. Manually achievable speeds are 2800 MHz (16-20-20-40-64), while default RAM is set to 2133 MHz.

T

Tchainiz

12-01-2016, 07:33 PM #1

Ram model PVS416G320C6K from Hynix. Mobo H610M DDR4 REV 1.2 with BIOS v29. CPU I3 12100F. Issue is booting fails without XMP support, showing error warnings or needing CMOS reset. Manually achievable speeds are 2800 MHz (16-20-20-40-64), while default RAM is set to 2133 MHz.

G

Geras9211
Member

67

12-01-2016, 08:54 PM

#2

I suggest keeping XMP as usual and then lowering the frequency from 3200 to 3000. (I’m doing a similar adjustment, 3600 to 3500)
Edited February 26, 2025 by leclod

G

Geras9211

12-01-2016, 08:54 PM #2

I suggest keeping XMP as usual and then lowering the frequency from 3200 to 3000. (I’m doing a similar adjustment, 3600 to 3500)
Edited February 26, 2025 by leclod

T

TylerSkillz
Member

198

12-02-2016, 01:14 AM

#3

provide the image of the burner to check if the IC isn't working with standard XMP settings. this could be a reason to request replacement under warranty for a model such as 3200, since it seems likely to be defective if it doesn’t run at stock XMP.

T

TylerSkillz

12-02-2016, 01:14 AM #3

provide the image of the burner to check if the IC isn't working with standard XMP settings. this could be a reason to request replacement under warranty for a model such as 3200, since it seems likely to be defective if it doesn’t run at stock XMP.

F

Frinex10
Posting Freak

806

12-02-2016, 06:11 PM

#4

Is this 1 kit or 2 kits?

F

Frinex10

12-02-2016, 06:11 PM #4

Is this 1 kit or 2 kits?

G

Goku_Jerome
Senior Member

428

12-02-2016, 06:33 PM

#5

I attempted, but it fails to start. After waiting six minutes, a warning appears and I must reload the defaults.

G

Goku_Jerome

12-02-2016, 06:33 PM #5

I attempted, but it fails to start. After waiting six minutes, a warning appears and I must reload the defaults.

X

xTripleMinerx
Posting Freak

846

12-04-2016, 04:15 PM

#6

One set of 2x8GB drives causes my motherboard to show just two available slots.

X

xTripleMinerx

12-04-2016, 04:15 PM #6

One set of 2x8GB drives causes my motherboard to show just two available slots.