Your car's engine isn't operating at maximum performance.
Your car's engine isn't operating at maximum performance.
Hey everyone, I own an Asrocks Steel B550M motherboard with a Ryzen 5700G and 16GB (CMK16GX4M1Z3600C18) LPX 16GB DDR4 RAM. It runs at 3600Mhz, but my system only shows 2667 MT/s and the CPU-Z reports 1330.8Mhz. I turned on XMP 2.0 in BIOS and adjusted the DRAM timing, but nothing changed. Any tips?
Review BIOS settings, it seems posting struggles at 3600MHz. Switch to JEDEC speeds, apply XMP profile, then reduce clock speed to 3200.
Was das? Denn falls es mehr als einmal neu startete, könnte es die Original-Einstellungen zurücksetzen. Du musst also folgendes tun, wie @PDifolco empfiehlt.
Try configuring it at 3200, which is the maximum your CPU supports.
Hi, Thanks for all the replies, I've followed Some of you suggestions(@ PDifolco , @ podkall , @ Needfuldoer ), by checking the Asrocks website i've found that The Ram Actually Doesn't Support Corssiar's This Particular Version Of size Sticks As Single full speed Ram.. And i couldn't possible find ram versions as suggested online in my country..but i've follwed Some of you guys suggestion as a result i've got... These are the settings I've Changed in the Bios, set The Ram Voltage to 1.35V As suggested in the Manual of the Ram & only different thing i've done from previous is setting the DRAM frequency dividers As 1800Mhz(since ddr suggestion from @ Mark Kaine ), as a result i've got this speed.. let me know if i could Do Better..! again "thank You.."
I believe you increased your RAM's performance to 3600MT/s, which is its maximum rated speed with XMP/EXPO activated. You might still gain a little more speed, but I recommend against it as it won<|pad|> can cause harm. You've hit the safe upper limit, that should be your target. Have a great day!