You connect the USB header to the appropriate port on your device, ensuring a secure fit and proper orientation.

F5F Stay Refreshed Hardware Desktop You connect the USB header to the appropriate port on your device, ensuring a secure fit and proper orientation.

Xo_PVP_Girl_oX
Senior Member

500

03-03-2016, 08:23 PM

Standard 90s board with an unusual USB header. Connecting it to a typical 9-pin USB port on the device. The diagram shows the connector labeled 1+ at the top and 2+ at the bottom. The NC pin is unconnected—no need to plug anything into it. Each wider connector’s wires are simply marked as Ground. Thanks!

Xo_PVP_Girl_oX

03-03-2016, 08:23 PM #1

LittleDiepp
Junior Member

03-04-2016, 06:11 AM

Connect the two connectors together into a single block. Use the VCC pins that match the +5V pins on the motherboard connector. Only the initial four pins are required.

LittleDiepp

03-04-2016, 06:11 AM #2

Connect the two connectors together into a single block. Use the VCC pins that match the +5V pins on the motherboard connector. Only the initial four pins are required.

iTzMxritz
Member

03-06-2016, 12:34 AM

Red measures +5V. Key/NC components aren't required; either can be connected. The first header line represents a USB port, the second is the second USB port.

iTzMxritz

03-06-2016, 12:34 AM #3

Red measures +5V. Key/NC components aren't required; either can be connected. The first header line represents a USB port, the second is the second USB port.