Yes, it appears correct. (NH-D15)
Yes, it appears correct. (NH-D15)
I concur, but as previously noted, ensure both cooler mounting screws are driven in fully. The stop occurs at the end of the threads where the spring clip is located. It's the combination of the springs and a firm stop on the threads that delivers the correct mounting pressure. "Repeat until both are completely secured. Caution: Gently tighten until they cease movement, avoiding overly strong force." noctua.at If you apply too much pressure with the driver, it likely means cross-threading.
It looks like I should likely begin again from the start. Also, the part where I’ve secured them feels quite secure.
Yeah, probably the best idea. You want to get 2-3 rotations on each per the manual before you proceed to tightening them down more. If both aren't threaded to start, then the one side not threaded will likely either not bite or cross thread. I usually pull up on the cooler like a monkey after I believe I've gotten 2-3 rotations into each screw to make sure they've bit into the threads.
Additionally, I stopped turning one because I heard a click—I think it was just a spring making a sound. Now I realize it might have been a simple creak. Both parts seem quite secure, like they’re tightly held together. So, I’m not sure if I should begin again to confirm the clip is properly connecting with the mounting bracket.
Adjust the components by securing the springs with a screwdriver until resistance disappears; you'll notice increasing firmness until it stops completely. Once done, further adjustment isn't possible, confirming they're securely fastened. Hand tightening works best for certain coolers and AIOs, though not all models use this method.
The handle length is crafted to allow a typical user to apply pressure just enough to secure screws without applying too much force. It becomes clear when it reaches its limit, making it easy to tell if you've hit the end. The transition shifts smoothly from gentle resistance to a firm stop.