XMP leading to instability
XMP leading to instability
Essentially, it works reliably only for about five minutes at most.
Configure your DRAM to operate at 1.4 volts and set the clock speed to 3200 MHz. Keep the timing settings automatic. Verify system stability. If unstable, reset the CMOS and increase voltage gradually until reaching 1.45V. Once stable, adjust timing parameters to 16-18-18-36 and test Cinebench R20 multiple times for consistency. If stable, fine-tune timings by raising 1-2 points until desired performance is achieved.
The farthest from the CPU and the one ahead of it by two positions is likely 2/4.
I'm struggling with the complex bios section of this tool. If I manage to fix the data fields, I'll give it another shot, thanks!