X299 gaming issue at A1 error code

felixNA
Junior Member

04-07-2017, 03:46 PM

Hello, I see the problem. Your motherboard is stuck at A1 error. The reset issue during IDE setup isn’t happening, but you mentioned trying to reset BIOS, change RAM, graphics card, and slots—nothing worked. Please check your connections, power supply, and try a clean boot or factory reset.

felixNA

04-07-2017, 03:46 PM #1

Sanchelo
Junior Member

04-07-2017, 07:10 PM

Disconnect the SATA/NVME units, verify if the RAM slots are intact. Inspect the display port cable—earlier advice suggested this fixes their A1 Post code.

Sanchelo

04-07-2017, 07:10 PM #2

Disconnect the SATA/NVME units, verify if the RAM slots are intact. Inspect the display port cable—earlier advice suggested this fixes their A1 Post code.

hotcone33
Member

204

04-07-2017, 10:05 PM

Check for any damaged RAM slots by testing connectivity. Also, ensure the system is running the correct version since it’s using a specific code. If it keeps shutting down and restarting, the issue might be with the software or power supply.

hotcone33

04-07-2017, 10:05 PM #3

alex_oo3
Member

249

04-08-2017, 01:56 AM

Inspect the Ram slots for any cracks or broken parts. This is uncommon, but I've encountered a cracked x299 board with the RAM slot damaged, which caused it to fail to boot. It usually appears on the Error page and then it's just a matter of moving down the list until nothing more can be tested.

alex_oo3

04-08-2017, 01:56 AM #4

Spaceface16518
Senior Member

564

04-09-2017, 11:06 AM

Just confirmed no broken slots, but the DRAM LED is red. The system booted up without any input from me, and it started on its own when I shut it down.

Spaceface16518

04-09-2017, 11:06 AM #5

Just confirmed no broken slots, but the DRAM LED is red. The system booted up without any input from me, and it started on its own when I shut it down.