Windows Installer on MacBook Pro 2019 fails to charge post-bootcamp setup.

F5F Stay Refreshed Hardware Desktop Windows Installer on MacBook Pro 2019 fails to charge post-bootcamp setup.

Spnky2324
Junior Member

09-06-2019, 02:00 PM

Hey there, the issue you're facing might be related to the battery health. After installing Bootcamp, the battery health dropped significantly, and it seems like the system detected a problem. Trying to let the battery drain fully before charging again could have stressed it further. Also, using Shift+Command+C to enter sleep mode might not have resolved the underlying issue. Check the battery status and consider running a full diagnostic to identify any deeper problems.

Spnky2324

09-06-2019, 02:00 PM #1

ricby
Senior Member

681

09-06-2019, 02:47 PM

The installation should not lead to this problem since it only sets up a fresh partition with Windows and drivers on the SSD. It shouldn’t be linked to any battery issues. Likely just a coincidence—someone might have more insight.

ricby

09-06-2019, 02:47 PM #2

CCS2001
Junior Member

09-06-2019, 08:46 PM

My ideas match perfectly. I also came across mentions about Windows struggling with battery handling, though it mainly concerned power management and efficiency.

CCS2001

09-06-2019, 08:46 PM #3

My ideas match perfectly. I also came across mentions about Windows struggling with battery handling, though it mainly concerned power management and efficiency.

caitlin_straet
Member

135

09-09-2019, 02:27 AM

No, the battery warning appears in Windows and macOS as a separate notification, not within the operating system itself.

caitlin_straet

09-09-2019, 02:27 AM #4

No, the battery warning appears in Windows and macOS as a separate notification, not within the operating system itself.

Assassin_AndyZ
Member

116

09-10-2019, 01:42 AM

It's a caution in both, regret that it wasn't more explicit earlier

Assassin_AndyZ

09-10-2019, 01:42 AM #5

It's a caution in both, regret that it wasn't more explicit earlier

marcemus
Junior Member

09-10-2019, 03:00 AM

Check the PRAM and restart the SMC.

marcemus

09-10-2019, 03:00 AM #6

Check the PRAM and restart the SMC.

nc432
Member

186

09-15-2019, 12:50 AM

Thanks for the suggestion, I completed the SMC reset but didn't see any improvement after that.

nc432

09-15-2019, 12:50 AM #7

Thanks for the suggestion, I completed the SMC reset but didn't see any improvement after that.