Windows fails to recognize your RAM.
Windows fails to recognize your RAM.
You're seeing different RAM detection values depending on the tool you're using. It seems your system thinks you have 8GB of DDR3 RAM, while the BIOS and CPU-Z report 4GB. Check your physical RAM modules—maybe one is not properly seated or recognized. Ensure all sticks are correctly installed and try reseating them. If the issue persists, consider testing with a different setup or consulting your motherboard manual.
I didn't immediately see it, but the BIOS mentioned I have 8GB.
Was das Problem erst nach dieser Information auftretend? Ich hätte es versuchen können, die Sticks zu entfernen und die Positionen zu ändern, also Slot 1 in Slot 3 und so weiter.
That's why it happened—try removing it and reinserting it. Make sure you stay grounded while working on it. (Consider using an anti-static wrist wrap.) How did you clean it? If you used any liquids, that could be a factor too. For PC hardware, use a soft brush to remove dust. Only apply isopropyl alcohol to the tougher areas if necessary.
Both stick models perform adequately, though the slot isn't functioning properly. My MBP only has two slots, and slot_1 isn't working either. I'm not sure when the PC began ignoring my RAM, but it becomes noticeable when using Chrome—it runs a bit slower than before. I checked Task Manager to confirm that my RAM isn't being detected.
You're only using the brush, and it seems like you might have shorted your RAM slot. However, both RAMs are functioning properly.
Use a flashlight or phone light to closely examine the slot. Check for any visible dust buildup that might prevent a proper connection. Cleaning typically involves gently using a soft brush to remove debris. It’s likely you’ve already done this, but it’s possible excessive dust was present. With good lighting, you should be able to spot the issue clearly. Good luck, and sorry if the connection failed completely.