What is the optimal method for securing and insulating wires after proper soldering?
What is the optimal method for securing and insulating wires after proper soldering?
I discovered some hot glue sticks intended for encapsulating electronics by Power adhesive TECHBOND 7718. This polyamide hot melt adhesive is suitable for potting and encapsulation, available in amber and black. It has very low melting points. Available at www.poweradhesives.com. I’m not sure it will work with a regular glue gun, but I have an arts and crafts glue gun that’s 40 watts. I believe an industrial-grade glue gun would be better. The high melting point might cause the wires to melt around 195°C, which could affect its performance.
I'm still thinking about applying hot glue over the wires of my PSU, assuming it might provide insulation up to 400v based on the glue brand. Regular hot glue can insulate up to 400v, isn't it? I just don't know if that's accurate. The power supply I'm using is a low voltage one.
Voltage is just part of the issue. Temperature effects in a power supply also need consideration. Can it maintain stability from room temperature up to 80°C through repeated cycles?