What is causing it to continuously malfunction?
What is causing it to continuously malfunction?
Indeed… certainly. It appears highly questionable now. I retract my belief that the problem originates with the primary power source, though I still advise operating the system using a battery backup device.
You brought it to a specialist, leading me to believe you purchased this machine as a ready-made system from a large retailer.
Systems assembled through these types of outlets frequently employ cost-cutting measures, and the power supply is often one of the areas where compromises are made. It might be too small or simply defective. “Around a year” was typically when my prebuilt computers would fail, and it almost always involved the power supply unit.
Here’s a list of potential issues:
The power supply unit – this seems like the most plausible explanation.
The graphics card
Insufficient fan speeds
Degraded thermal paste on the CPU
I regret that you ended up spending money at an electronics store without resolving your issue. My last experience with such a place involved a fan detaching from the CPU because its plastic base had fractured. The store advised me to leave it for repair, but I went home and located a replacement at numerous locations ranging from $3 to $12.
I received a call the following morning; they informed me the part was unavailable, forcing me to purchase an entirely new PC. (This was questionable practice, though not wholly improper – it was an older model nearing its end-of-life support by Microsoft.)
Consequently, I researched installation videos for a new fan and acquired one with a sturdy base, successfully repairing the problem. This realization then prompted me to begin constructing my own computers; most components are straightforward to install, but securing the fan proved to be the most challenging aspect, leading me to transition into building my own systems.
Incidentally, that former computer store charged $60 for a power supply unit worth approximately $15.
Consider installing software like CPUID HWMonitor to monitor your temperatures. Observe them closely to detect if they spike right before a Blue Screen of Death occurs. Alternatively, navigate to the ASUS UEFI – you’ll find a fan control feature in the center section. Select the “auto” setting and proceed with the provided steps. This UEFI will automatically adjust fan speeds based on rising temperatures. I’ve found it (up until now) to be a remarkably effective setup, especially since it requires minimal intervention.