What could be causing the PC to fail to start when the power button is pressed?
What could be causing the PC to fail to start when the power button is pressed?
My PC fails to start or boot when I press the case button, yet the motherboard indicates power is reaching it and it appears operational. This knowledge comes from an ASUS TUF-Gaming X570-Plus with LED glow on the board. I recently replaced a new SSD (Teampgroup T-Force) and switched cables to the GPU (corsair to cablemod). I reset the CMOS, tried another power supply, cleaned everything, verified connections, and disconnected all non-essential components from the PSU and motherboard before it would boot. It worked perfectly before these changes.
When your computer case features an old-fashioned Reset switch, use it. If the wire has fallen off the back of the Power switch, you might be able to solder it back in place. You can also look for a wide range of inexpensive switches on platforms like Amazon, eBay, and AliExpress—just choose one that matches the shape of your PC's switch.
Welcome to the forums, newcomer! I understand this because your setup uses an ASUS TUF-Gaming x570-Plus with LED lighting on the motherboard, which suggests standby power is active. Have you connected the front panel header for the power button correctly? If yes, try connecting the +ve and -ve pins/terminals of the power button header on the board; if this resolves the issue, your case's power button might be faulty. Regarding cases, please mention the make and model so I can assist further.
Consider shorting the power and ground pins on the motherboard front panel connector. If that resolves the issue, check your front power switch and connections for problems. If not, examine the replacement PSU cables as the likely cause.
Shorting it succeeded! The case is a Musetex ATX PC Case-Glass side door Mid Tower Case (907-MS6). Since the wire seems damaged, should I try fixing it or just replace the case? Also, here’s the link to the cables I purchased:
https://www.amazon.com/dp/B08GJPJYF5?ref...asin_title
Right away I understood I needed to stick with the corsairs instead.
If your computer case includes an old-fashioned Reset switch, use it. If the wire has fallen off the back of the Power switch, you might be able to solder it back in place. You can also look for a wide range of inexpensive switches on platforms like Amazon, eBay, and AliExpress. Just search for a switch that matches the shape of your PC's switch.
https://www.amazon.com/SaiTech-ATX-...85933&sprefix=pc+power+switch,aps,182&sr=8-21
I thought you could handle that and it functioned well! Thanks! I'll also examine the cables.
Review the cables from the switch to the front panel connector. It's possible they might have come out of place.
If the switch or cable is faulty, reach out to the support team for the case.
They could either provide a free replacement or offer one at a small cost.
It appears to be a custom design, making it unlikely to find a suitable match.
Consider connecting the reset switch to the two power pins—it should function just fine.
We seldom require the reset feature.
Alternatively, you might consider purchasing remote switches, which could be a better fit.
For instance:
https://www.amazon.com/Computer-AZMXDVP-...nel+switch