Welcome to the setup process! Ready to begin?
Welcome to the setup process! Ready to begin?
Hello everyone! I just started my PC and followed the setup instructions from the guide. At this point, I'm in the Windows setup section, but I can't locate my SSD when I try Disk Management—it doesn’t appear. I’m confused about what should show up: just a C: drive or both C: and D: drives in the Files view? Any advice would be greatly appreciated! Thanks!
It was the slot with the heat shield at the top! My motherboard had two slots, but one lacked that shield. I also misselected the wrong drive on the PC partpicker since their SSD wasn't listed. It's this one! Amazon.com: Western Digital 1TB WD Green SN350 NVMe Internal SSD Solid State Drive - Gen3 PCIe, QLC, M.2 2280, Up to 3,200 MB/s - WDS100T3G0C : Electronics
Hello everyone! I just started my PC and followed the setup instructions from the YouTube guide. At this point, I'm in the Windows setup section, but I can't locate my SSD when using Disk Management—it doesn’t appear. I’m confused about what should show up: only a C: drive or both C: and D: drives in the Files view? Thanks for your help!
The installation was placed on the middle section of the drive, labeled with "NTFS." On the Sn350, after Windows setup, the entire drive minus boot and recovery sections became your C drive. The C drive along with disks 0, 1, and 4 are complete unless there are any missing components.
You anticipated a different setup scenario. The installation process only used one drive, leaving the other uninitialized. A second drive would have appeared if it were present.