Was das Befestigungsmontagesystem entfernt worden?
Was das Befestigungsmontagesystem entfernt worden?
Hello, I'm attempting to fit a Scythe FUMA2 air cooler onto a pre-built HPOmen830-110. The mounting bracket is stuck to the board—after taking off the front screws that secure it. Additionally, the screws on the AIO cooler from the original desktop don't match the size of the Fuma 2's screws, making it difficult. Can you find a way to install this without harming the motherboard? Thanks!
Consider using a bit of warmth from a hair dryer or heat gun, but avoid setting the temperature too high to prevent damage. Do you have an image that explains your method?
Yeah, it's right here. https://imgur.com/a/DvJyVVt I could provide some more if needed; I'm going to give the hairdryer thing a shot.
If the heat isn't effective, apply 90+ isopropyl alcohol to loosen the adhesive and gently work underneath using an old credit card or similar tool. This method has helped with items wrapped in double-sided tape. Be careful not to force the card too much—slide it parallel to the board and move slowly. If you notice improvement, let the alcohol sit a bit longer and try sliding the card further. Avoid applying excessive pressure.
And keep an eye on it, since there are SMD components on the back of the board near the center. Be careful not to push too low and knock them off.