voltageI have a major problem with my computer.
voltageI have a major problem with my computer.
I was trying to understand what was going on when the situation became complicated. The issue started around August 15 when I installed the latest version of Spider-Man for PC. Although the game itself seemed smooth and well-optimized, it was quite demanding on the CPU. This became apparent when I began experiencing problems during gameplay. My setup includes an RTX 3060 Ti with ASUS Dual OC, a Ryzen 7 5800X processor, 16GB of RAM at 3600MHz, a 500W power supply, and the MOBO ASUS B450M-K II. When the game would crash, I had to restart and hoped my friend could help. They suggested checking the CPU voltage limit in BIOS, which I did. Initially, adjusting it to 1.100V seemed promising, but after restarting and entering BIOS, I pressed the + button repeatedly until a warning lit up. I thought this might raise the voltage to 1.5V, but it didn’t fix the issue. Eventually, I restarted and noticed the problem persisted—only the logo appeared on screen while other components like RGB lights, the cooler, and GPU signals remained unresponsive. Despite coolers spinning normally, everything felt unstable. I learned from others that sometimes the system would boot with just the logo and a few key presses, but the screen would freeze or show only static. I was frustrated because I had to force shutdowns and deal with the uncertainty of whether the problem was hardware-related or software. I also discovered that I had accidentally pressed the chipset button instead of the correct BIOS reset option, which added to my confusion. The situation was stressful, especially since this computer holds value for me and my family. I’m worried about potential damage from repeated attempts, so I’m considering whether a replacement might be the best option. I’m hoping it’s just a matter of CPU or GPU failure, but I’m not sure if the warranty would cover it. I’m open to advice and would really appreciate any insights into what might be causing this issue.
Taking the battery out doesn't help unless you stop power from the PSU. Turn off or unplug the device. Press the power button while still unplugged to discharge capacitors. Pull out the battery after 10 minutes. Connect a CMOS jumper for 15 seconds. Reassemble and test again.
Sure, I can clarify the distinction between a Clear CMOS Jumper and Battery Removal. The main difference lies in what each action addresses. Removing the battery often resolves power-related issues, while clearing the CMOS jumper can reset system settings and firmware. Many people assume they do similar things, but they actually target different aspects—power management versus configuration settings. Regarding your concerns about GPU, CPU, and memory corruption, setting the VDDCR to +0.50000 can affect power delivery and potentially cause instability if not properly calibrated. If this led to the PC freezing or failing to boot, it might indicate a hardware fault or improper configuration. The frozen BIOS screen suggests a deeper issue that could stem from either power or firmware problems. If the motherboard shows components but doesn’t respond, it’s likely a hardware concern rather than just a software setting.
VDDCR is the main core component. It differs from a clear CMOS jumper and battery removal plus jumper, as the clear CMOS handles all user configurations. Deleting the battery will erase time, date, passwords, and related BIOS settings. Applying defaults via the BIOS menu matches using just the jumper. Yes, it's feasible to harm the CPU and motherboard by setting the VCore value too high, even with manufacturer protections. I wouldn't risk starting the machine without a proper full CMOS reset. If the VCore is set too high—say +0.50V with a default 1.3V VID—you've exceeded 1.8V to the CPU.