F5F Stay Refreshed Hardware Desktop updated the bios but the computer remains unresponsive on RAM/CPU with no power indicator.

updated the bios but the computer remains unresponsive on RAM/CPU with no power indicator.

updated the bios but the computer remains unresponsive on RAM/CPU with no power indicator.

O
oO_Nebula_Oo
Junior Member
30
02-12-2022, 03:10 AM
#1
Hey there, just wrapped up installing my new PC a few days back and everything was working fine. Suddenly CS2 crashed, so I spent some time updating. I updated my BIOS (ASUS TUF X670E-PLUS WIFI) and managed to boot into the BIOS screen. After setting RAM to 6000MHz via EXPO, the PC restarted and kept showing two warning lights. First it stuck on the RAM issue for about half an hour, then switched to CPU and stayed there for roughly an hour now. What should I do next? Should I let it run out or try reverting the BIOS settings? Also, did skipping the flash drive insertion during the update affect things? Need advice!
O
oO_Nebula_Oo
02-12-2022, 03:10 AM #1

Hey there, just wrapped up installing my new PC a few days back and everything was working fine. Suddenly CS2 crashed, so I spent some time updating. I updated my BIOS (ASUS TUF X670E-PLUS WIFI) and managed to boot into the BIOS screen. After setting RAM to 6000MHz via EXPO, the PC restarted and kept showing two warning lights. First it stuck on the RAM issue for about half an hour, then switched to CPU and stayed there for roughly an hour now. What should I do next? Should I let it run out or try reverting the BIOS settings? Also, did skipping the flash drive insertion during the update affect things? Need advice!

D
DanielEmpire
Posting Freak
781
03-05-2022, 03:23 AM
#2
You successfully installed the new BIOS and reverted to the updated BISO to configure XPO. Then, remove the CMOS battery to reset your BIOS and RAM defaults. The resulting image should display your board with the CMOS battery highlighted.
D
DanielEmpire
03-05-2022, 03:23 AM #2

You successfully installed the new BIOS and reverted to the updated BISO to configure XPO. Then, remove the CMOS battery to reset your BIOS and RAM defaults. The resulting image should display your board with the CMOS battery highlighted.