Updated GPU and RAM settings are causing red indicators on the CPU and DRAM. System is stuck in restart loop.
Updated GPU and RAM settings are causing red indicators on the CPU and DRAM. System is stuck in restart loop.
Video of issue:
Watch it here: https://youtube.com/shorts/5x21T0uBdWQ?feature=share
Last week I bought an RTX 4060ti with 16GB and 64GB DDR4 RAM, installed the new components, turned on the power, and was greeted by red indicators on the MOBO for CPU and DRAM. The previous RAM, which had worked five minutes earlier, still displayed red lights. I suspected a possible damage to the MOBO during installation, so I ordered a replacement identical to the original. After replacing the MOBO in the case, reconnecting everything and restarting, the red lights reappeared. This issue has never happened before and is quite annoying.
I've tried all possible solutions: reseating the RAM, adjusting the CMOS jumper, letting it run indefinitely in its restart loop for hours, and more. Nothing resolved it. My power supply is 600w plus 80W, so I doubt that's the cause. It wouldn't be the GPU either, since it would also show a red light.
Please help :[
Details:
MOBO - ASRock x570 phantom gaming 4.
CPU - Ryzen 5600x.
PSU - Corsair VS Series 600w plus 80.
RAM upgrade target - G.SKILL Ripjaws V Series 64GB (2 x 32GB) 288-Pin PC RAM DDR4 3200
Hey there,
Let's start with the basics. Your PSU isn't ideal for a gaming rig—no one here will back it up. I'd recommend replacing it right away for peace of mind. Also, check if you're using A-XMP or DOCP for the memory; you can also adjust it manually by setting the voltage and timings yourself. Make sure the CPU is in good shape too, and inspect the pins for any damage.
I've been using this PSU since 2019 without any problems. It works well for gaming and 3D rendering. The issue only began after I attempted to install new components. Even when I used the old GPU and RAM sticks, the same problem persisted. I don't know what caused it. How should I proceed? I assume it's not the CPU, since it functioned properly before the changes.
All right, that's acceptable so far. It isn't a suitable power supply for a gaming rig, but more suited for office equipment. The issue lies in the PSU using inexpensive parts to keep costs low. If it can't deliver sufficient power, the system might fail completely and could damage components. The warranty is expired (just three years), so a replacement is necessary.
Adjusting RAM voltage and timings is handled via the BIOS settings.
Watch: https://www.youtube.com/watch?v=w4sx-GuY3CA
You can also enable A-XMP/XMP/DOCP in the BIOS, which acts like an auto-overclock for your RAM. This might improve performance. Test it and observe the results.
Also, what BIOS version are you using? You can verify this on the motherboard menu under CPU-Z. It should be L5.01 or 4.50, as these versions support 40xx Nvidia cards.
Updating the BIOS can also resolve memory compatibility problems, so it's a good idea to keep it current.
Ouch. It seems the mobo or CPU might be damaged.
You could attempt a bios flashback without needing to boot up, just for the mobo to receive power:
https://www.asrock.com/support/QA/FlashbackSOP.pdf
Give it a try and hopefully it will get you running. Then we can proceed from there.
Swapped the CPU, upgraded the PSU, changed the MOBO, but the issue remains.
Updated notes: I decided to document what I've already attempted.
- Removed CMOS
- Updated MOBO, CPU, PSU, and RAM
- Replaced RAM modules one by one
- Ran it continuously in boot loop