Unable to reach the router's main interface.
Unable to reach the router's main interface.
Hello, I own two routers at home. The second one is linked to the main router but isn't set up as a repeater. I decided to change its settings but ran into an issue. I can't reach the second router's homepage. (I used an Ethernet cable) When I opened the Windows terminal and ran "ipconfig -all," no router IP appeared. I tried connecting via WiFi with my phone, performed a scan using Fing, and found only my phone and laptop in the network. I checked the IP address under the router, but it doesn't seem to work. Anyone experienced this problem or has advice? I'm trying to avoid resetting everything because I fear losing access if I do. My router model is Asus RT-N12+
When errors occur in the setup, returning to factory settings is usually the safest option. After confirming your wireless devices are linked to the correct network and still can't reach the WebUI through your default gateway, a reset is recommended. You might also attempt using a wired connection, though that didn't resolve the issue. Always use LAN interfaces instead of WAN.
If the second router wasn't set to "bridge" mode, it probably uses an IP outside its own subnet. You won't be able to reach devices on another subnet unless you've manually added routes or connected directly to that subnet and adjusted your NIC settings. I support a hard reset to restore default settings and then access the admin panel using the router's guidance.
I didn't make any errors during setup. The router is functioning properly, but I can't reach its interface. (I've tested all LAN connections) Resetting might help, though I'm concerned it could disrupt access. I'll try again later. (This router isn't mine; my parents are handling it. They mentioned replacing it if it stops working. I can't afford it—I'm saving for a new graphics card.)
In the wireless area, copy the SSID name, mode, authentication details, and password from your main router. Switch the broadcast channel to a different one, preferably one that doesn’t clash with nearby networks. On the 2.4GHz frequency, channels 1, 6, and 11 are available without interference. If many neighbors use 2.4GHz, pick a channel that avoids overlap and has minimal signal strength from others. In the LAN section, update the second router’s IP address to a unique value—such as 192.168.1.2 instead of the default—and match its subnet mask with the primary router. Turn off the DHCP server on the second router since it won’t need to manage IPs. If default gateway and DNS settings remain, input the primary router’s IP (e.g., 192.168.1.1) for the second router. In the WAN section, turn off WAN and NAT features. Within Administration, set the operation mode to 'Access Point Mode'. Once configured, open your primary router’s interface and adjust the DHCP range so it doesn’t include the static IP of the second router. For example, if your primary router is at 192.168.1.1 and the second router is at 192.168.1.2, set its DHCP start address to 192.168.1.10. Power down the second router and connect an Ethernet cable from a LAN port on the primary router to a LAN port on the second router. Restart the second router and test connectivity to its wireless network.