Unable to configure DRAM at 3600 MHz.
Unable to configure DRAM at 3600 MHz.
I managed to configure my DRAM to 3600 and activate the XMP profile earlier, but now everything resets after replacing my CPU. I’m unsure why I can’t revert it to 3600 again. The screenshots show the intended destination, yet when I set it to 3600 instead of Auto, the PC restarts and shows an error: “overclocking memory failed, use default setting.” It wouldn’t boot afterward. I had to revert to Auto. Did I overlook something? Thank you ahead of time!
Load the XMP file first to set the memory to 1.3500V, then adjust the frequencies as needed.
It's possible you missed the silicon draw and the memory controller might be faulty. The CPU's memory controller influences RAM stability. Swapping the CPU could change the controller, which is usually the main reason for RAM issues—not the RAM itself. It should function properly with an older CPU.