Too many supporters, not enough places
Too many supporters, not enough places
I own six case fans and one CPU fan (all PWM) with limited connections—just one CPU fan header and two case fan headers on the motherboard. Since there are no drive bays to add a fan controller, it's unclear how to manage all the fans, which include three intake and three exhaust fans.
Your situation doesn't include any drive bays? That's unusual. You might find fan controllers that fit in a rear slot, like this one.
Isokolon :
Solution A: obtain a fan controller. Cost around 40 dollars.
Solution B: use splitters, place two fans per header and connect two to the PSU — drawbacks are lack of control and it will run on 12V (or 7/5V with adapters)
a: I don’t have space for a fan controller; my case lacks drive bays
b: Are there options to manage all fans, do three-way splitters exist?
They do but can cause problems. Check you main board specs on how much power they allow to output over the header.
Also there are fan hubs that can be placed inside the case. However I'm not sure if they can be configured or just output full speed.
Also there's an external fan controller by NZXT that gets connected via usb2
Isokolon :
They function but may lead to issues. Verify your main board specifications regarding the power output capacity through the header.
Additionally, there are fan hubs that can be installed inside the case. I’m uncertain if they support configuration or just full-speed operation.
There’s also an external fan controller from NZXT connected via USB2.
I’ve been conducting extensive research and found these details: http://www.akasa.com.tw/update.php?tpl=p...-CBFA06-30
It’s a powered 3-way splitter. Would this setup be suitable? If yes, can I have two fans of the same type and one different type on the same splitter (2x140mm and 1x120mm)?
I initially considered purchasing the NZXT controller, but it’s not readily available at a reasonable price right now—it would have been perfect.
Isokolon :
Consult your main board manual to understand the power output capabilities of the board over the fan.header. If three fans exceed the header's design limits, you may encounter issues.
Review your board manual
The splitter in the link has a SATA connection for the PSU; do I still need to verify the header in that scenario?
The link didn't open earlier today. You can link it directly to your PSU. It's possible you won't need a splitter if your PSU has enough connectors. The main drawback is that the energy output isn't controlled, meaning all fans connected will spin at full speed continuously.
Isokolon :
The link didn't open earlier today. You can link it directly to your PSU. You might not even need a splitter if there are enough connectors on your PSU. The main issue is that the energy output isn't controlled, so all fans connected to the PSU will spin at full speed constantly. Therefore, just because it fits both the PSU and the motherboard doesn't guarantee anything? Will it always run at maximum power?