To stop PL1 and PL2 throttling, adjust their respective settings or disable them as needed.
To stop PL1 and PL2 throttling, adjust their respective settings or disable them as needed.
You can prevent PL1 and PL2 throttling by adjusting your system settings. Since the issue occurs when your CPU voltage exceeds 8 watts, try disabling power limits or throttle controls. For your Intel Pentium Silver N5030 with UHD 605, you might want to remove the FIVR (Fan Control) feature or adjust the power management settings in your BIOS/UEFI. This will allow the CPU to run at full capacity without automatic throttling. If you're unsure, consult your motherboard manual or seek help from a tech support forum.
I believe you've got throttlestop ready, just press the activation button, navigate to the tpl menu and adjust pl1, pl2, and pp0 limits to 99999. Set all the sliders except the last one fully to the right. Then check the device manager for dynamic tuning, dptf, or keyword processor participant—remove those completely (upload a picture if you want confirmation). Effects take effect instantly, so you won’t need to restart. I did this on my dad’s Craptop with a similar CPU and it worked perfectly. Bye bye throttling!
I understand you're familiar with stopping Intel Dynamic Tuning, but based on your message, it seems this approach may not apply to your situation. Shall we explore other options?
No problem at all. I've faced some throttling issues with PL1 and PL2, but I've tried other fixes too.
An embedded controller is restricting the CPU's power usage to 8W. You must update the controller settings. Are you running any performance enhancement tools? It seems a program on your system is restricting ThrottleStop, limiting its access to just two of the four cores. I’m not certain this affects ThrottleStop’s operation. Inform the performance tool to avoid interfering with ThrottleStop or disable it altogether. ThrottleStop should display monitoring information for all four cores, confirming it has complete access.