Tips for boosting your system's performance
Tips for boosting your system's performance
System specifications include an i5 4570 processor, ASUS m87z motherboard, GeForce GTX 1070 TURBO-GTX1070-8G with 8GB RAM, Corsair vengeance memory, EVGA 550 GS Gold power supply, a standard hard drive. I have limited experience with overclocking and have experienced crashes until reaching optimal settings. I'm seeking guidance on potential risks, damage prevention, driver instability issues, and advice for safely increasing performance.
When using only EVGA PrecisionX or MSI Afterburner, adjusting core or memory clocks won't harm the card. If the driver fails, it indicates an unstable overclock, and you should reduce the overclock slightly.
Most users overclock by installing Unigine Heaven or Valley Benchmark.
Here:
https://unigine.com/en/products/benchmarks
Begin by increasing your core clock by 10 MHz while running the benchmark, then raise it until you notice artifacts or instability (driver crashes). When crashes or artifacts disappear, lower the overclock by about 5 MHz and note the new value. Then reset the core clock to +0 and repeat for memory overclock, usually starting around +25 or +50.
When using only EVGA PrecisionX or MSI Afterburner, adjusting core or memory clocks won't harm the card. If the driver fails, it indicates an unstable overclock, so reduce the overclock slightly.
Most users overclock by installing Unigine Heaven or Valley Benchmark.
Here:
https://unigine.com/en/products/benchmarks
Begin by increasing your core clock by 10 MHz during benchmarking, then raise it until you notice artifacts or crashes. Stop when instability appears, then lower the overclock by about 5 MHz and note the new value. Return to +0 MHz for the core clock and repeat for memory overclock—typically start with +25 or +50 MHz, adjusting as needed for stability. Once a suitable setting is found, combine both overclocks. You might need to slightly reduce the memory overclock for stability before finalizing.
Jayhawker32 shares tips for those using EVGA PrecisionX or MSI Afterburner. Adjusting core or memory clocks won't harm the card, but if crashes occur, it suggests an unstable overclock. Usually, people use Unigine Heaven or Valley Benchmark. Start by increasing core clock by 10 MHz during benchmarking until instability appears. Reduce the overclock by a few MHz when crashes return, then note the new value. Reset core to +0 and repeat for memory overclock, starting with higher values like +25 or +50. Once stable, combine both overclocks. You might need to lower memory overclock slightly for stability. Good luck with your setup!