This product is no longer functional.

Pages (2): 1 2 Next

NightsSky
Junior Member

11-03-2016, 08:48 AM

NightsSky

11-03-2016, 08:48 AM #1

sniperboy650
Senior Member

735

11-03-2016, 04:03 PM

Reset the CMOS and attempt again. It seems you removed the cooling for the CPU during operation, which isn’t ideal. This action likely didn’t damage the chip but may have caused it to throttle. Your steps probably didn’t impact the motherboard, though other actions remain unclear.

sniperboy650

11-03-2016, 04:03 PM #2

MikaCupcake
Member

11-20-2016, 08:13 PM

MikaCupcake

11-20-2016, 08:13 PM #3

TheMightyJoel
Junior Member

12-01-2016, 12:31 PM

Tested the initial two units, planning to try the GPU and RAM next. Note that the pump is connected to the CPU_OPT header; some sources suggest these boards may fail to power up if no fan-related headers are detected.

TheMightyJoel

12-01-2016, 12:31 PM #4

Nik_Master16
Member

140

12-07-2016, 02:57 PM

It seems the RAM wasn't the problem. I observed that when I turned it on, the motherboard lights would blink once and then stop working. Pressing the power button didn’t shut it down either.

Nik_Master16

12-07-2016, 02:57 PM #5

It seems the RAM wasn't the problem. I observed that when I turned it on, the motherboard lights would blink once and then stop working. Pressing the power button didn’t shut it down either.

Tjeard_
Member

179

12-07-2016, 03:49 PM

The RAM reset fixed the issue, but it's now just restarting the system.

Tjeard_

12-07-2016, 03:49 PM #6

The RAM reset fixed the issue, but it's now just restarting the system.

eskzz
Posting Freak

909

12-08-2016, 08:45 AM

It looks like reinstalling the RAM resolved the problem. Everything appears stable now—no issues or crashes. Still there’s the pump noise, but it’s manageable. Thanks for the update!

eskzz

12-08-2016, 08:45 AM #7

It looks like reinstalling the RAM resolved the problem. Everything appears stable now—no issues or crashes. Still there’s the pump noise, but it’s manageable. Thanks for the update!

Sertero28
Senior Member

589

12-13-2016, 11:33 PM

Disconnect the water pump connector from the header and attempt to power it back on. A brief pause won’t cause harm. If the issue persists, consider removing the GPU from the setup as it isn’t required for the boot process.

Sertero28

12-13-2016, 11:33 PM #8

SeanTheSun
Junior Member

12-27-2016, 01:37 PM

Well said. Let's move forward.

SeanTheSun

12-27-2016, 01:37 PM #9

Well said. Let's move forward.

westmountwild
Member

12-27-2016, 07:43 PM

#10

It seems the RAM issue was linked to a power or reset problem. The fact that you didn’t remove the battery from the motherboard but briefly altered the CMOS reset might have triggered the boot failure.

westmountwild

12-27-2016, 07:43 PM #10

Pages (2): 1 2 Next