F5F Stay Refreshed Hardware Desktop This part is meant for the be quiet 900 revision 2 and you need to figure out where it fits.

This part is meant for the be quiet 900 revision 2 and you need to figure out where it fits.

This part is meant for the be quiet 900 revision 2 and you need to figure out where it fits.

H
halowarspros
Member
Find
115
08-15-2020, 09:02 AM
#1
The LED connector on the motherboard for that fan controller is placed on the Aorus Ultra Z490 Rev 1 board. It’s not required, but you should confirm before installing. Thanks in advance if this seems obvious!
Reply
Reply
H
halowarspros
08-15-2020, 09:02 AM #1

The LED connector on the motherboard for that fan controller is placed on the Aorus Ultra Z490 Rev 1 board. It’s not required, but you should confirm before installing. Thanks in advance if this seems obvious!

Reply
Reply
K
kungfutyla
Posting Freak
Find
780
08-16-2020, 07:32 AM
#2
Review the motherboard specs, yet the focus is on the Aorus Z370 LED connector details.
Reply
Reply
K
kungfutyla
08-16-2020, 07:32 AM #2

Review the motherboard specs, yet the focus is on the Aorus Z370 LED connector details.

Reply
Reply
R
Rucian
Member
Find
142
08-16-2020, 08:24 AM
#3
Check if the controller uses a 3-pin or 4-pin connector. Remember, the 3-pin ones are actually 4 pins wide, with just one middle pin left empty.
Reply
Reply
R
Rucian
08-16-2020, 08:24 AM #3

Check if the controller uses a 3-pin or 4-pin connector. Remember, the 3-pin ones are actually 4 pins wide, with just one middle pin left empty.

Reply
Reply
A
AdmiralHawk
Junior Member
Find
41
08-16-2020, 02:37 PM
#4
It's marked as C on the schematic for the case fan controller board. I think it uses four pins.
Reply
Reply
A
AdmiralHawk
08-16-2020, 02:37 PM #4

It's marked as C on the schematic for the case fan controller board. I think it uses four pins.

Reply
Reply
C
coolman9222
Posting Freak
Find
754
08-16-2020, 05:50 PM
#5
It seems to be a 4-pin connector, though verification with the actual connector is recommended. This matters because connecting a 3-pin device to a 4-pin header—often not feasible due to extra space in the connector—could damage the controller and possibly the LEDs. If it's truly a 4-pin (12V) connector, use LED_C1 on the lower left or LED_C2 on the upper right. Choose the position that makes running the cable easiest.
Reply
Reply
C
coolman9222
08-16-2020, 05:50 PM #5

It seems to be a 4-pin connector, though verification with the actual connector is recommended. This matters because connecting a 3-pin device to a 4-pin header—often not feasible due to extra space in the connector—could damage the controller and possibly the LEDs. If it's truly a 4-pin (12V) connector, use LED_C1 on the lower left or LED_C2 on the upper right. Choose the position that makes running the cable easiest.

Reply
Reply