This item isn't available for posting.
This item isn't available for posting.
Hello all, Introduction / Description: So this is my first build, I bought an Asus Tuf Gaming X570-Plus and everything was working great until after I had installed windows. This is when I went to relocated the computer to update it using the Ethernet cable, I placed on ground and moved cable from back of monitor and when I connected it no display, I am thinking to myself what the F it was just working. I moved back to the other room and noticed a white LED on the VGA light, and a green LED on the Boot Light, After doing some research online, I was informed that this may have been a bad mobo, but I feel that its not the mobo, being my 1st build I dont have anything to test with to narrow down the factors. Now when I plug the power on turn on the fans spins slow and the orange light comes on for Ram, after 2-3 seconds of that that the red light comes on for CPU, after like 2-3 seconds that light it changes to the VGA that is when all the fans kick on at a higher rate, the Lower fan on the mobo stops spinning and the after about 5 seconds a green light is on for the LED and it basically sits there for a while unitl i press just 1 time on the power button and the system shuts down completely. Components AMD RYZEN 7 3800x - CPU Asus Tuf Gaming X570-Plus - Motherboard radeon rx 580 gts - GPU (2) 16gb 3200 Vengence - DDR4 Ram Corsair CX650W Powersupply 2TB Seagate 3.5 Barracuda - SATA HDD 1TB Crucial - SSD Troubleshooting: I had removed the GPU - Radeon rx 580 gts I removed the Ram sticks I tested each Ram Bay to see if that is the issue and the light came on every time I re-seated all the cables by removing and re-placing (Not replace as swapping out but replace as take out and plug back in) I have not RMA the Mobo but I feel that may be my next step as this is a headache, after some research online i seen that this issue is with alot of people and that the board is basically a bad board :-( just my luck. Any suggestions would greatly help, Thanks in advance. IMG_8918[1].HEIC
Use the GPU's output during startup. On my TUF X570-Plus, the debug LED lights white initially and then turns off after a few seconds. Green means a boot device issue—verify all drives have SATA power and data. Reset CMOS afterward. Taking the GPU out won't fix the problem.
Verify your PSU connections. Green with white indicates it's booting but without VGA. This issue occurred on my X570. It turns out the PCIe link to the PSU was loose. Power down everything, including the PSU, then reconnect the PCIe cables directly into the PSU. Also confirm your video cable is securely attached.