This build is new, and only three of six standoffs are installed. Shorting or weight distribution might be a concern.
This build is new, and only three of six standoffs are installed. Shorting or weight distribution might be a concern.
I have a Prime Z690-P motherboard in a Phanteks Eclipse G500-A, and I've had a bit of a problem with the standoffs. I couldn't quite get them all to align, felt like the IO shield was pushing the board back, so I struggled somewhat getting more than 2 standoffs to align perfectly with the motherboard. Eventually the top right standoff accidentally slipped into the motheboard's hole perfectly, so I took my chance out of frustration to screw in those that fit as a result. It looks like this: x x o x o o X are standoffs that were screwed in to the motherboard, O are standoffs that are not screwed in and still sit underneath. Though now that I've gotten to the part where I am about to install the PSU, I've started to get a little worried I might have made a mistake I feel like it's gonna short something if I turn it on, or the weight of the GPU might be an issue. Though I don't want to unplug everything I've already plugged in in order to reposition the board, since I'm worried I might end up bending or twisting something if I start pulling out cables and putting them back in. (Edit) There are no standoffs that are touching the edge or the center of the board. All of them are near the spots where the holes are. Little unsure what I should do. Technically the other 3 *can* fit, though out of frustration I took the best chance I got to screw in the most standoffs I could while installing the board. I'm kinda worried that my own impatience might end up costing me some components... Any thoughts?
Absolutely, give it a thoughtful approach. Even with minimal risk, aiming for perfection is wise. Plus, knowing you completed the task correctly gives you confidence. Regarding the board alignment, removing the I/O shield might help, but you'd need to take the board out to inspect. Look for any warping or bending on the back of the case—especially around the standoffs. It’s normal for them to shift slightly, but if they’re loose, it could affect performance. Take your time and be careful.
Motherboard tray information? Also, the motherboard seems to have an IO shield already installed (probably). Edit: OP confirmed it isn't pre-installed. Please take a photo of the shield from both the back and inside of the case after installing the board so we can verify alignment and any adjustments needed. Also, make sure to check for bent components in the PC case, as mentioned by @bmx6454. Updated: September 24, 2023 by Poinkachu
Ensure nine mounting points are available for your ATX board. The more components you fit, the better performance.
IO shield needed to be connected to the case first before the motherboard. Everything appeared to fit and pass through the shield, but I’m uncertain about moving it now. It might be better to try repositioning the board, as suggested. I’m hesitant about leaving some parts unscrewed.