There are numerous boot and BIOS problems that require attention.
There are numerous boot and BIOS problems that require attention.
I adjusted the VDDCR CPU voltage without thinking much of it, which caused a lot of problems. I reset the BIOS and the settings stopped working because I now have to manually pick a boot drive instead of changing them automatically. The motherboard still shows the correct DRAM order—CPU led, then VGA, then RAM, then boot—but I can’t switch between them at once. After resetting the RAM, I ran a memory diagnostic and found no issues. I’m stuck with my 2400MHz RAM instead of the expected 3200MHz, since I can’t modify BIOS settings or change the boot process simultaneously. Any advice would be greatly appreciated.
Visit the official site to obtain the latest BIOS update and install it on your motherboard's BIOS.
i did the following steps:
turned off the pc
shut down the psu
removed the cmos
waited 10 minutes
installed a new cmos
restarted the pc with the black screen prompting to press f1 for setup
it loaded into bios
selected the drive
the pc started normally
i repeated this several times and each time it followed the same process
Yes, the battery was swapped in. Did the replacement battery come with a tiny plastic cap on the underside that you took off before putting it in?
Are you asked to restart because the automatic reboot after the BIOS update indicates a new fTPM firmware version or processor?