The XMP format isn't functioning properly.
The XMP format isn't functioning properly.
I'm reviewing the details you shared. The motherboard supports DDR4 speeds, but the memory options listed don't match those specifications. There seems to be a mismatch between the supported profiles and the ones you're trying to use. You might want to check the official documentation or contact support for compatibility guidance.
I chose not to reinstall Windows but encountered around 20 blue screens. I tried my old memory and it functioned, leading me to believe the new memory wasn’t compatible. However, when reinstalling Windows with the new memory, it again triggered blue screens. After updating the BIOS, the issue was resolved. Still, Windows tends to show blue screens immediately when XMP is enabled. I used @porina because I didn’t realize how multiquote worked at first.
For stability, you can use the system file checker tool from Microsoft support. It helps repair missing or corrupted files without needing a full reinstall. The process may occasionally detect errors during a clean installation, which is normal.
I attempted to click the repair option multiple times amidst the similar 100 blue screens before finally reinstalling Windows. Updating the BIOS resolved the issues with the new memory as long as I kept it at the default settings. Can you try a manual basic overclock, perhaps slightly smaller than XMP? I’m not sure how to do that properly. On older motherboards, the settings were simpler, but on these newer ones, everything is divided into many different options, making it hard to just adjust clock speed, CAS latency, and voltage without knowing what each does.
You might want to explore different relaxed timing options. Begin at XMP 3200, adjust the main settings to 22-22-22—the typical middle standard timing. All other parameters can stay auto. Test it out; if it works, consider moving closer to the 16-18-18 ram rating. Or keep XMP but lower the speed slightly and observe the results.
I attempted to adjust the System Memory Multiplier to 3000 yesterday but only received 3000 and had to reset the BIOS after rebooting. This time it displayed the full "DDR4-3000" instead. I realized the code refers to CAS-tRCD-rRP-tRAS settings, which I hadn’t understood before. Changing all four digits seemed necessary, not just one entry. I’m still unsure how to modify memory voltage and was surprised to boot into Windows on DDR4-3000 with 19-19-19-38 timings for the first time without a blue screen. I think the voltage remains at 1.2 since I haven’t altered it. Increasing the voltage might be needed for better performance and lower timings.