The upgrade process didn't go as planned.
The upgrade process didn't go as planned.
So today I upgraded my rig from a 3900X to a 5800X3D and from an 2080Ti to a 7900XT. The motherboard is a Gigabyte X570S Gaming X with BIOS version F4. From what I understand, F4a came out to support the 5800X3D, then F4 was released as a stability patch, and F5 was introduced later for optimization on that model. I intended to switch to F5 once everything seemed stable.
First, I opened up the case, removed the 2080Ti, and cleared out space. Next, I took off the pump block (Arctic 240 AIO) and cleaned the 3900X and the heat spreader on the Arctic using nail polish remover and cotton pads. Then I installed the 5800X3D, added Kryonaut, and reinstalled the AIO. After that, I inserted the 7900XT and connected everything—monitor, keyboard, mouse.
When I turned it on, nothing happened. The screen appeared to detect something but then went blank into standby. I’m not sure if this is normal after a CPU change, especially since I haven’t upgraded in years. I left it running for now, but might consider swapping back the 5800X3D to check if things improve. Any tips would be appreciated!
Besides the missing monitor cable in the GPU, have you explored other BIOS settings? Your motherboard includes a flash bios option, so you don’t need to rely solely on your previous CPU for updates. You might want to try pressing F4a or using the newest BIOS, even though it’s unclear why not just install the latest one. There haven’t been many updates that would remove support for your 5800X3D graphics card in recent releases; have you attempted a CMOS reset? Also, does the PC power on normally with fans already spinning?
It was my initial update and they advised following the release sequence instead of jumping to the newest version.
RE BIOS - refer to what I mentioned earlier. I need to learn more about BIOS flashing and its process but that's fine. I'm ready to try it. I haven't attempted a CMOS reset yet; I'll do that when I'm back at my desk. I can also remove one stick of RAM to test. Overall, the PC powers on normally and all components activate—GPU lights, AIO fans, everything works as expected. EDIT: Will update once I've tried these steps. It might take some time since I'm currently away from the PC. Edited July 13, 2024 by The Pizza Man
varies the information on the downloaded page affects the process. Some systems handle the newest BIOS updates smoothly, while others may require placing the BIOS on a USB drive in a specific port, flashing it when the PC starts, and checking for lights or sounds indicating success. If issues persist, try reverting to an older BIOS version and gradually adjust settings until you reach a compatible one, such as F1 to F4a or F4.
I powered up the PC this morning without doing anything else, and it functioned immediately. Maybe it just required a bit more time to settle in. Last night it ran for a few hours but still seemed unresponsive.
Turning off the power switch might have been beneficial as well... I've noticed this before. Double-check your DDU NVIDIA drivers, and make sure to update the latest chipset and CPU drivers.