The system is unable to publish.

CakeSFD
Member

226

12-21-2019, 01:58 PM

You're experiencing issues after updating your BIOS with Dragon Center on an x390 Meg Ace running a 3700x. The problem might stem from instability caused by the update. Checking the little debug display for consistent readings could help identify if it's stuck at 22 or freezing at 0d. Consider reinstalling the BIOS or consulting official support resources for further assistance.

CakeSFD

12-21-2019, 01:58 PM #1

bert1167
Junior Member

12-21-2019, 02:23 PM

No, I didn't clear the CMOS.

bert1167

12-21-2019, 02:23 PM #2

No, I didn't clear the CMOS.

TempLate_YT
Senior Member

424

12-21-2019, 03:20 PM

I took out the CMOS battery and installed a new one.

TempLate_YT

12-21-2019, 03:20 PM #3

I took out the CMOS battery and installed a new one.

trj55
Member

175

12-28-2019, 05:09 PM

The jumper on your motherboard can reset BIOS settings and restore them to their original state. Clearing it also lets you change the BIOS password. To do this, power off your PC, locate the jumper near the CMOS battery, set it to Clear/CLR, then turn it back on after rebooting. If you want a permanent fix, replace the CMOS battery and follow the instructions for that method.

trj55

12-28-2019, 05:09 PM #4

dt118lw
Member

198

01-05-2020, 02:42 AM

The manual doesn't specify which pins to disable, and there aren't any clearly labeled components like the ones mentioned. Shorting those parts seems to cause the PC to shut down. Removing the CMOS chip is being considered to check its impact.

dt118lw

01-05-2020, 02:42 AM #5

AaronJJ
Junior Member

01-25-2020, 12:17 PM

The manual provides a clear and detailed guide on locating the item.

AaronJJ

01-25-2020, 12:17 PM #6

The manual provides a clear and detailed guide on locating the item.

Mel_Kawaii
Member

182

01-25-2020, 03:28 PM

Mel_Kawaii

01-25-2020, 03:28 PM #7

nathy2402
Member

01-25-2020, 05:15 PM

Successfully resolved the issue by installing the BIOS update on a USB stick using another PC, then flashing it via the motherboard's BIOS button. Now the system is functioning properly.

nathy2402

01-25-2020, 05:15 PM #8

Successfully resolved the issue by installing the BIOS update on a USB stick using another PC, then flashing it via the motherboard's BIOS button. Now the system is functioning properly.