F5F Stay Refreshed Hardware Desktop The system fails to start when adjusting the RAM rate.

The system fails to start when adjusting the RAM rate.

The system fails to start when adjusting the RAM rate.

P
PotatoCactus
Member
Find
63
06-13-2020, 09:46 PM
#1
I recently upgraded my motherboard to an Asus TUF B550 and enabled the DOCP profile. However, when I set the RAM speed to 3600—its recommended setting for my graphics cards—the system fails to boot. Only a lower speed of 2666 allows it to start. This issue didn’t occur with my previous motherboard. What should I do? I’ve already checked the forums for solutions.
Reply
Reply
P
PotatoCactus
06-13-2020, 09:46 PM #1

I recently upgraded my motherboard to an Asus TUF B550 and enabled the DOCP profile. However, when I set the RAM speed to 3600—its recommended setting for my graphics cards—the system fails to boot. Only a lower speed of 2666 allows it to start. This issue didn’t occur with my previous motherboard. What should I do? I’ve already checked the forums for solutions.

Reply
Reply
S
skyawolf
Junior Member
Find
28
06-13-2020, 10:35 PM
#2
Verify the SOC voltage and raise it to 1.15V, then set the primary timings manually.
Reply
Reply
S
skyawolf
06-13-2020, 10:35 PM #2

Verify the SOC voltage and raise it to 1.15V, then set the primary timings manually.

Reply
Reply