F5F Stay Refreshed Hardware Desktop The new RAM doesn't recognize XMPP.

The new RAM doesn't recognize XMPP.

The new RAM doesn't recognize XMPP.

K
Kablahblahblah
Junior Member
Find
5
07-02-2025, 06:01 AM
#1
You're dealing with a situation where your system is struggling to boot due to memory issues. The motherboard you're using supports up to 16GB of RAM, but you've only filled four sticks. It's possible the remaining sticks aren't being recognized properly, or there might be compatibility problems. Check if all four modules are installed and try removing one at a time to see if booting becomes possible. Also, ensure your BIOS is set to support the maximum supported RAM configuration. If the issue persists, consider updating your BIOS or consulting Gigabyte's support resources.
Reply
Reply
K
Kablahblahblah
07-02-2025, 06:01 AM #1

You're dealing with a situation where your system is struggling to boot due to memory issues. The motherboard you're using supports up to 16GB of RAM, but you've only filled four sticks. It's possible the remaining sticks aren't being recognized properly, or there might be compatibility problems. Check if all four modules are installed and try removing one at a time to see if booting becomes possible. Also, ensure your BIOS is set to support the maximum supported RAM configuration. If the issue persists, consider updating your BIOS or consulting Gigabyte's support resources.

Reply
Reply
C
Cookie_Manster
Member
Find
99
07-02-2025, 07:49 AM
#2
You can't simply add two more of the same setup and expect it to function at 4400mhz without adjustments. Your kit is eligible for QVL at 2 but not at 4 sticks. Consider loading XMP, then adjusting the speed to 4000mhz before disconnecting from the BIOS.
Reply
Reply
C
Cookie_Manster
07-02-2025, 07:49 AM #2

You can't simply add two more of the same setup and expect it to function at 4400mhz without adjustments. Your kit is eligible for QVL at 2 but not at 4 sticks. Consider loading XMP, then adjusting the speed to 4000mhz before disconnecting from the BIOS.

Reply
Reply
A
Amaniasky
Member
Find
155
07-02-2025, 03:56 PM
#3
No single motherboard+CPU setup ensures a 4400 2x8 or higher; consider 4000 first if stable, then lower timings. M.MSI is the top choice, but even then VCCI and SA voltage must be increased considerably.
Reply
Reply
A
Amaniasky
07-02-2025, 03:56 PM #3

No single motherboard+CPU setup ensures a 4400 2x8 or higher; consider 4000 first if stable, then lower timings. M.MSI is the top choice, but even then VCCI and SA voltage must be increased considerably.

Reply
Reply
S
Soldier_Games
Member
Find
60
07-02-2025, 05:39 PM
#4
Your board uses a daisy-chained design, which means adding four DIMMs will increase the load on the memory system overall. The IMC will need extra capacity, probably making it impossible to run this configuration at 4400Mhz. Consider lowering the speed or adjusting timing and voltage settings, but be careful with that.
Reply
Reply
S
Soldier_Games
07-02-2025, 05:39 PM #4

Your board uses a daisy-chained design, which means adding four DIMMs will increase the load on the memory system overall. The IMC will need extra capacity, probably making it impossible to run this configuration at 4400Mhz. Consider lowering the speed or adjusting timing and voltage settings, but be careful with that.

Reply
Reply