The new motherboard is not responding and the USB is overloaded.
The new motherboard is not responding and the USB is overloaded.
Just installed my new motherboard, MSI Z270 Gaming M7. When I power it on, it shows an error about over current on a USB device and restarts after 15 seconds. I tried removing all USB devices and internal headers, but it still doesn’t work. No peripherals connected yet, still getting the same message. Any suggestions?
You might have reset the CMOS settings. It's possible you forgot to power it back on.
I've tried resetting the CMOS and the problem is still there. They were both working before I swapped the board this morning, and they are plugged into the recommended slots (2 and 4) l. This may help however do have not found any form of jumper plug on my motherboard, and attempting to reset the CMOS by shorting the reset CMOS plugs didn't do anything. I've more or less disconnected everything now. I only have one ram stick in there (slot 2), no graphics card, no front panel IO, no back panel IO, no internal USB headers. I only have the CPU 8 pin power, the 24 pin ATX power, and three fans connected, one is PWM (for CPU) the other two are three pin and plugged in correctly (ie not plugged into the PWM controlling lane). Any ideas what else I could try?