The motherboard is unresponsive in your system.
The motherboard is unresponsive in your system.
It's positioned roughly in the center of the board... the sides are wobbly on both sides, yet the middle stays still... and I've removed every screw.
Yes, those central standoffs are visible through the holes. I can provide an image of that if you'd like.
You likely feel resistance from the rear side of the interface pushing the board against that edge. Position your fingers along the front edge, aligning with the ram. Push backward toward the rear interface. Observe if the screw aligns properly in its holes. While maintaining this back pressure, apply a slight upward force to test lifting.
It looks like they aren't press fit in. They should have enough room to slide out, but maybe there is an alignment issue and they are rubbing hard against the sides of the holes, causing lot's of static friction. I agree with above. And lift from very close to the hole without bending the board.
Consider employing a screwdriver or comparable tool to reshape the standoff away from the edge of the hole it contacts.