The graphics card must be reconnected in order to power on the system...assistance required?
The graphics card must be reconnected in order to power on the system...assistance required?
I recently made some changes to my setup and everything initially functioned perfectly. After a fresh start, the PC failed to power on. I verified the power connector on the motherboard, which seemed to work again, though it appeared loose at times. The next day the same problem persisted, leading me to suspect a hardware issue. Whenever I powered off the system, the power indicator stayed lit without fully shutting down, preventing startup until the GPU was removed and reinserted. I also tested removing RAM temporarily and unplugging the entire machine, but neither resolved the issue. Switching to sleep mode didn’t help either—it would attempt to boot but a fan spiked up, forcing a hard restart. This is really frustrating. Please let me know if you need specific guidance or resources, though I’m still learning about PC building. My setup includes: 12th Gen Intel Core i5-12600K, Nvidia 2070, ASRock H670M Pro, RS 32GB RAM, Corsair Vengeance LPX 3600MHz, and a Bequiet Straight Power 11 750W PSU. Thanks!
Be honest, before damaging your PCIe slot, remove the board and test it on a different enclosure to check its behavior. There could be a minor issue that stops it from shutting down.
Updated the bios now, appreciated the suggestion even though nothing changed. The bios were actually five versions outdated. All other choices are disabled.
You're asking about the meaning of something on a box and how to turn it on without the built-in power switch. It sounds like you're dealing with a device that needs manual activation.
It seems the female end of the plug on the connector isn't secure. To check, gently shake the cable side to side—no movement should occur. Since you don’t know your PSU’s specs, you might need to replace the cord if it’s modular; if not, carefully squeeze the plug lightly. The lead could be too short because of how the cable is managed. Excess tension often comes from a tight bend at the connection. If possible, let the cable extend so the bend is as far away from the joint as you can while keeping it neat. Small adjustments can make a big difference.
After several more troubleshooting sessions, I replaced the PSU cables and inspected the front panel connectors by unscrewing them. A closer look revealed the problem: one of the Display Port cables had an issue, which disappeared after the swap. Thank you for your assistance!