The Ethernet ports aren't functioning properly.
The Ethernet ports aren't functioning properly.
You transform the bare wire into an RJ45 connector for your PC. This involves using punchdowns to shape the wire into terminals on a punchdown block or keystone, converting it into a usable port. Another option is to attach male RJ45 jacks directly at the end of the cable and use keystone couplers, which requires more effort but provides a more secure link. All connections are made with patch cables leading to a switch, then to a router and finally to your modem.
If I were you, I’d get a patch panel. You can’t just link every cable together. You need a switch for that. Most people either mount RJ45 jacks on the wires and connect them straight to the switch, or they purchase a patch panel and run the cables to it. A patch panel usually holds several Ethernet ports on one side and provides a spot to connect those cables on the other. You’d link an Ethernet cable from the patch panel to your switch to start communication. If you want to share internet, you must connect your gateway (modem/router) to the location where all the wires end, since that’s the only way to bring internet throughout the house.
Great to hear! I'll move forward with setting up the router downstairs near the cable, thanks for the tips. I'm familiar with an Ethernet switch and think connecting the wires by color should work. The big wire tangle is just a minor issue. No need for a professional if it's simple like this. The link you shared looks helpful too!
Another inquiry for you: For an unusual reason, one of the Ethernet panels appears to be linked to another Ethernet panel somewhere else in the home. I investigated and achieved speeds exceeding 100 Mbps (500 Mbps). Does this indicate those two Ethernet panels are damaged, or could it be a daisy chain? Is it feasible to connect Ethernet panels in this way? I'm quite puzzled now. There are seven Ethernet ports in my house, along with seven blue twisty cables in that bundle. Each port connects to another, yet there are still seven Ethernet cables present? Additionally, my home has coax and telephone lines (many more of these), hinted by the telephone punch-down block nearby.
That's actually a much better option than what I suggested earlier. I'll add it to the Amazon wishlist for future reference. Cat5e supports up to 1,000 Mbps, but using just two pairs (four wires) of the eight in a Cat5e cable gives you 100 Mbps performance. It's likely that some of those wires aren't connected to the wall jack.
It appears the two devices are already linked without a daisy chain. You'll likely need to check the connections manually to identify the cables, if they weren't connected at the socket ends. It's possible they were removed from the back of the sockets and replaced with a direct wire.
I truly believe it's the right setup, but after removing one socket I didn’t spot any second cable. It’s strange since there are seven Ethernet ports and seven CAT5e cables throughout the building. You might try using the coaxial cable from the bypassed panel and connect it to an Ethernet cable, then pull it all the way down to the patch panel. Is it typical to attach fished coaxial or Cat5 cables inside a home? I just want them gone.
It's a solid inquiry, though I'm uncertain. You'd want to use conduit for easy replacement, but it's possible they're secured with staples. The best approach is testing it out.