The device fails to power up.
The device fails to power up.
I recently assembled a gaming PC and it powers off normally when in sleep mode, but when trying to wake it by moving the mouse or pressing the power button, everything lights up and the screen goes black. I think this might be related to Windows 10, though I can't locate a solution. Any advice would be appreciated!
Ensure the BIOS is up to date and the graphics drivers are current. It seems there might be confusion about the sleep modes—full shutdown (S4) instead of light sleep (S1). Refer to the Microsoft documentation on sleep states for details. Also, note that some BIOS versions allow you to manage these sleep settings. Your 2011 Gigabyte board supports this functionality.
Consider turning off Hybrid Sleep in Windows power settings. Check how it affects your performance. If you're using a hard disk as the main operating system drive, verify that S3 is activated in the BIOS. Searching for your motherboard model may help locate similar problems, though I don't have your specifications.
I intended to disable Hybrid mode to test performance. The system indicates S3 operates in a low-power state, reminding the motherboard to retain some RAM and USB components for quick recovery. S4 enters hibernation, confirming the boot location change. S5 is fully off, except for USB devices that stay powered for fast startup. G5 or G3 are completely powered down until the designated hard button is pressed and the power supply acknowledges the command.
I entered the BIOS but didn’t locate any settings for sleep mode. I noticed my RAM is set to 2133 while my system has 3000. Should I try increasing it to 3000? I’m cautious because the Trident Z seems to clash with Ryzen, and a big jump might not be ideal.
Hey, you seem identical in hardware setup. My RAM sits at 2933 and I just upgraded my BIOS to 0902 last night. It crashed on the first post—did the four beeps? Then it restarted and worked afterward. This seems to happen now, though I’m too lazy to dig deeper; maybe it’s power consumption or insufficient heat when cold booting. I’m not certain about your RAM, but 2400MHz is fine, so set that as your default. Anything above that is extra, not required. Regarding the sleep issue, this isn’t really relevant—this is just a minor side task since you mentioned it. Have you updated all your GPU and Mobo drivers? Also, after disabling hybrid mode, have you tried disabling Windows PCIe power management? Go to Start, type “edit power plan,” and adjust it to moderate or off. It’s unusual, but your monitor might be the culprit if the graphics card isn’t sending a wake signal because it thinks sleep mode is active. If your monitor uses DVI HDMI or DP, set it to the specific port you’re using instead of letting it auto-detect. That way, it always monitors one input regardless of any “wake spike.”