F5F Stay Refreshed Hardware Desktop The damaged motherboard caused a crash rate of 5900 per two weeks!

The damaged motherboard caused a crash rate of 5900 per two weeks!

The damaged motherboard caused a crash rate of 5900 per two weeks!

M
MooMoo2011
Senior Member
Find
690
03-03-2020, 04:24 AM
#1
Your voltage was higher than before you reduced it.
Reply
Reply
M
MooMoo2011
03-03-2020, 04:24 AM #1

Your voltage was higher than before you reduced it.

Reply
Reply
S
Samwich113
Junior Member
Find
11
03-10-2020, 06:21 PM
#2
Occasionally if things get too intense, my board fails the orange light test. VGA. I managed to clear the CMOS and remove the battery, then left it alone, but it still behaves the same when I check back later. Someone mentioned they were updating their BIOS while it was still broken. My solution? Using my reliable GTX 580. Just drop in some dust and press start. This has happened four times now—I think it’s my mistake. Pushing the MEMS too much probably caused it. Perhaps try starting with a non-UFI GPU?
Reply
Reply
S
Samwich113
03-10-2020, 06:21 PM #2

Occasionally if things get too intense, my board fails the orange light test. VGA. I managed to clear the CMOS and remove the battery, then left it alone, but it still behaves the same when I check back later. Someone mentioned they were updating their BIOS while it was still broken. My solution? Using my reliable GTX 580. Just drop in some dust and press start. This has happened four times now—I think it’s my mistake. Pushing the MEMS too much probably caused it. Perhaps try starting with a non-UFI GPU?

Reply
Reply
Q
Quinnikus
Junior Member
Find
6
03-18-2020, 05:02 AM
#3
It’s highly improbable your CPU is the issue. You’d need to test with different voltages to trigger damage, which you didn’t do. The default motherboard settings shouldn’t cause this, and a solid PSU would support normal operation.
Reply
Reply
Q
Quinnikus
03-18-2020, 05:02 AM #3

It’s highly improbable your CPU is the issue. You’d need to test with different voltages to trigger damage, which you didn’t do. The default motherboard settings shouldn’t cause this, and a solid PSU would support normal operation.

Reply
Reply
K
Killermph
Junior Member
Find
7
03-18-2020, 08:26 AM
#4
I returned the CPU and they replaced it; they discovered a problem. Now I'm hesitant about installing it on the motherboard. I only reduced the voltages to achieve better temperatures and prolong the CPU's life, since I didn't like the 1.5V reading I was seeing... but that didn't actually happen.
Reply
Reply
K
Killermph
03-18-2020, 08:26 AM #4

I returned the CPU and they replaced it; they discovered a problem. Now I'm hesitant about installing it on the motherboard. I only reduced the voltages to achieve better temperatures and prolong the CPU's life, since I didn't like the 1.5V reading I was seeing... but that didn't actually happen.

Reply
Reply
W
WildFlow
Member
Find
187
03-26-2020, 06:16 AM
#5
The default configuration ranges from 1.25V to 1.5V based on the load. I documented my complete issue a week ago.
Reply
Reply
W
WildFlow
03-26-2020, 06:16 AM #5

The default configuration ranges from 1.25V to 1.5V based on the load. I documented my complete issue a week ago.

Reply
Reply
S
syhr11
Junior Member
Find
46
03-28-2020, 09:30 PM
#6
It would be helpful if they clarified any problems by returning them. If you accidentally affected the CPU, it might be due to incorrect handling.
Reply
Reply
S
syhr11
03-28-2020, 09:30 PM #6

It would be helpful if they clarified any problems by returning them. If you accidentally affected the CPU, it might be due to incorrect handling.

Reply
Reply
M
Marvin929
Junior Member
Find
36
03-29-2020, 03:01 PM
#7
They mentioned they faced the same issue with me, but it seems my GPU is functioning properly now.
Reply
Reply
M
Marvin929
03-29-2020, 03:01 PM #7

They mentioned they faced the same issue with me, but it seems my GPU is functioning properly now.

Reply
Reply