The computer fails to start because of an XTU issue.

F5F Stay Refreshed Power Users Overclocking The computer fails to start because of an XTU issue.

noahsent
Member

150

01-08-2016, 03:57 AM

I experimented with XTU a bit and only increased my CPU's voltage by 1.00. Immediately after, my computer displayed a black screen. After waiting roughly 15 minutes it stayed black. I turned off the machine and tried to restart it, but the same issue persisted. I haven't made any changes in the BIOS, just in XTU, and I can't run any programs anymore. Can someone assist me with this?

noahsent

01-08-2016, 03:57 AM #1

BakenCookies
Member

212

01-08-2016, 05:12 AM

Usually, without a proper shutdown, XTU goes back to its default settings...
(We all wish the mentioned '1 V core jump/offset' never happened in the BIOS...)

BakenCookies

01-08-2016, 05:12 AM #2

Usually, without a proper shutdown, XTU goes back to its default settings...
(We all wish the mentioned '1 V core jump/offset' never happened in the BIOS...)

arc9819
Member

219

01-08-2016, 01:31 PM

full system spec?

arc9819

01-08-2016, 01:31 PM #3

full system spec?

HitTom9886
Member

229

01-12-2016, 04:17 AM

You increased the CPU Vcore by an integer value, not a fraction. That could damage the CPU.

HitTom9886

01-12-2016, 04:17 AM #4

You increased the CPU Vcore by an integer value, not a fraction. That could damage the CPU.

MrEpic_
Member

01-13-2016, 11:54 AM

Does the system post to Bios? If yes, navigate to Bios and initiate the system in Safe Mode. This should stop it from applying your settings in XTU once more.
I question whether xtu supports increasing the VCore by 1.0v, though I'm not certain.

MrEpic_

01-13-2016, 11:54 AM #5

JustSano
Junior Member

01-16-2016, 02:11 PM

Usually, without a proper shutdown, XTU goes back to its default settings...
(We all wish the mentioned '1 V core jump/offset' never happened in the BIOS...)

JustSano

01-16-2016, 02:11 PM #6

Usually, without a proper shutdown, XTU goes back to its default settings...
(We all wish the mentioned '1 V core jump/offset' never happened in the BIOS...)